--------
In message <[email protected]>, Bruce Griffiths
writes:
>It has been used to machine/polish crystal quartz waveplates and
>to machine/polish the surface of silicon wafers before uses for
>MEMS fabrication. Its even been used to carve channels in silicon
>wafers in such applications.
The images on this page gives a good impression about the current
skill-level in that area:
https://www.azonano.com/article.aspx?ArticleID=2740
I'm pretty sure that it is not the machine control but rather the
metrology that would be the challenge.
--
Poul-Henning Kamp | UNIX since Zilog Zeus 3.20
[email protected] | TCP/IP since RFC 956
FreeBSD committer | BSD since 4.3-tahoe
Never attribute to malice what can adequately be explained by incompetence.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
