Got the answer in the previous email :) On Mon, Feb 19, 2018 at 5:28 PM Didier Juges <[email protected]> wrote:
> What do you mean by “Adafruit” pinout? > > On Fri, Feb 16, 2018 at 11:50 AM Mark Sims <[email protected]> wrote: > >> No, the Tbolt does not have a separate receiver board... plus its' GPS is >> rather special... the RF chain is locked to the OCXO so it does not produce >> any sawtooth error. >> >> The Lucent KS firmware expects the GPS to support the older 6/8 channel >> messages. The newer 12 channel messages are different. >> >> BTW, I just did a Motorola M12 to Adafruit pinout board. The M12 form >> factor and pinouts are also used by a lot of other timing receivers. Why >> Adafruit? Because it is breadboard friendly, has enough pins for all the >> signals that one expects, and my GPS to RS-232 adapter board has an >> Adafruit connector on it. >> >> ---------------- >> >> > Never having opened my TBolt, are the GT-8736 boards of use to replace >> the aging and partly deaf receiver in that? Or for a KS-24019? >> _______________________________________________ >> time-nuts mailing list -- [email protected] >> To unsubscribe, go to >> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >> and follow the instructions there. >> > _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
