celo wrote: > Since I have not used an amp/DAC before I am trying to figure it out how > to connect. Currently, I connected the Mojo via USB to SBT (EDO). > > Yes, (@Man in a van), I connect the 3.5mm cable to the headphone output > on the Mojo and connect the RCA ends to my amp (no volume on the amp). > So, no need to use line out mode (I assume). > > What I want to know is that what amp is feeding my speakers? :) The Mojo > or my amp?:) I do not think Mojo's amp can be bypassed. I am confused > here as how it works. So you are basically relying on the mojo to behave as a pre-amp, because your "amp" has no volume control so is presumably a fixed gain power amp. Given that the volume control on the mojo has no remote control capability I would do the following:
Turn SBT vol all the way down Set mojo to "line" level output via magic button sequence Use SBT volume control to control sound level. If you find you can't get to even 30% vol on SBT without it being too loud you may need to lower the mojo volume setting further. But note that both these devices use digital volume controls. The mojo has a higher resolution digital volume control than the SBT, but you still may lose resolution at low volumes on either, depending on the gain of your power amp. ------------------------------------------------------------------------ drmatt's Profile: http://forums.slimdevices.com/member.php?userid=59498 View this thread: http://forums.slimdevices.com/showthread.php?t=105793 _______________________________________________ Touch mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/touch
