Hi Pete I haven't been following the post. But on my Radio I have to go into the menu and tell it I'm using the remote mic, might be possible Rick/ kd4dra
Sent from my Verizon Wireless BlackBerry -----Original Message----- From: Pete Lilja <[email protected]> Date: Sun, 30 May 2010 10:43:32 To: <[email protected]> Subject: Re: [tracker2] Alinco DR-135 and T2-135 - Unexpected Behavior I just tried this om my DR-135 / T2-135 combo and I still get no remote functions from my mic except the Up/Down and keying the mic for voice. I there something to do other than pulling that red / black pair from the circuit board? Pete KC0GPB On Sat, May 29, 2010 at 1:49 AM, Keith VE7GDH <[email protected]> wrote: > > > Gary WB0BZR wrote... > > > > Now if I can just figure out why the keypad on the mic doesn't work..... > > Search the archives for "remote mic functions" from a couple of years > back. e.g. http://groups.yahoo.com/group/tracker2/message/3421 > > "With the red-black cable disconnected, I can't find > anything that doesn't work. What I gain is that while the radio > is in digital mode (i.e. the T2-135 is enabled) I regain the > remote MIC functions. With it not in digital mode, none of the > remote MIC functions except the UP/DOWN buttons work, > and DTMF can be sent." > > It's the same whether you have the stock TNC installed or the T2-135. > If you pop the lid again and remove that two conductor cable off to the > side of the circuit board, you will regain some of the functions... e.g. > you could put it in digital mode and punch a frequency into the keypad, > and then take it out of digital mode. > > 73 es cul - Keith VE7GDH > -- > "I may be lost, but I know exactly where I am!" > >
