Ah, I see. Thanks anyway (glad I didn't pull my hair out looking in the Alinco manual for a Yeseau menu setting! [?] )
Pete On Sun, May 30, 2010 at 4:16 PM, <[email protected]> wrote: > > > I don't have the dr-135 I have ft+857just thought it might be a > possibility. Sorry wish I had one tho. Rick > > Sent from my Verizon Wireless BlackBerry > ------------------------------ > *From: * Pete Lilja <[email protected]> > *Date: *Sun, 30 May 2010 16:14:28 -0500 > *To: *<[email protected]> > *Subject: *Re: [tracker2] Alinco DR-135 and T2-135 - Unexpected Behavior > > > > Hi, Rick, > > I just looked through the manual and don't see using the remote mic as a > menu option. Perhaps I'm over-looking the obvious...can you be a bit more > specific? > > Pete > KC0GPB > > On Sun, May 30, 2010 at 1:47 PM, <[email protected]> wrote: > >> >> >> Hi Pete I haven't been following the post. But on my Radio I have to go >> into the menu and tell it I'm using the remote mic, might be possible >> Rick/ kd4dra >> >> Sent from my Verizon Wireless BlackBerry >> ------------------------------ >> *From: * Pete Lilja <[email protected]> >> *Date: *Sun, 30 May 2010 10:43:32 -0500 >> *To: *<[email protected]> >> *Subject: *Re: [tracker2] Alinco DR-135 and T2-135 - Unexpected Behavior >> >> >> >> I just tried this om my DR-135 / T2-135 combo and I still get no remote >> functions from my mic except the Up/Down and keying the mic for voice. >> >> I there something to do other than pulling that red / black pair from the >> circuit board? >> >> Pete >> KC0GPB >> >> On Sat, May 29, 2010 at 1:49 AM, Keith VE7GDH <[email protected]> wrote: >> >>> >>> >>> Gary WB0BZR wrote... >>> >>> >>> > Now if I can just figure out why the keypad on the mic doesn't >>> work..... >>> >>> Search the archives for "remote mic functions" from a couple of years >>> back. e.g. http://groups.yahoo.com/group/tracker2/message/3421 >>> >>> "With the red-black cable disconnected, I can't find >>> anything that doesn't work. What I gain is that while the radio >>> is in digital mode (i.e. the T2-135 is enabled) I regain the >>> remote MIC functions. With it not in digital mode, none of the >>> remote MIC functions except the UP/DOWN buttons work, >>> and DTMF can be sent." >>> >>> It's the same whether you have the stock TNC installed or the T2-135. >>> If you pop the lid again and remove that two conductor cable off to the >>> side of the circuit board, you will regain some of the functions... e.g. >>> you could put it in digital mode and punch a frequency into the keypad, >>> and then take it out of digital mode. >>> >>> 73 es cul - Keith VE7GDH >>> -- >>> "I may be lost, but I know exactly where I am!" >>> >> >> > >
<<360.gif>>
