Hi, Rick,

I just looked through the manual and don't see using the remote mic as a
menu option.  Perhaps I'm over-looking the obvious...can you be a bit more
specific?

Pete
KC0GPB

On Sun, May 30, 2010 at 1:47 PM, <[email protected]> wrote:

>
>
> Hi Pete I haven't been following the post. But on my Radio I have to go
> into the menu and tell it I'm using the remote mic, might be possible
> Rick/ kd4dra
>
> Sent from my Verizon Wireless BlackBerry
> ------------------------------
> *From: * Pete Lilja <[email protected]>
> *Date: *Sun, 30 May 2010 10:43:32 -0500
> *To: *<[email protected]>
> *Subject: *Re: [tracker2] Alinco DR-135 and T2-135 - Unexpected Behavior
>
>
>
> I just tried this om my DR-135 / T2-135 combo and I still get no remote
> functions from my mic except the Up/Down and keying the mic for voice.
>
> I there something to do other than pulling that red / black pair from the
> circuit board?
>
> Pete
> KC0GPB
>
> On Sat, May 29, 2010 at 1:49 AM, Keith VE7GDH <[email protected]> wrote:
>
>>
>>
>> Gary WB0BZR wrote...
>>
>>
>> > Now if I can just figure out why the keypad on the mic doesn't work.....
>>
>> Search the archives for "remote mic functions" from a couple of years
>> back. e.g. http://groups.yahoo.com/group/tracker2/message/3421
>>
>> "With the red-black cable disconnected, I can't find
>> anything that doesn't work. What I gain is that while the radio
>> is in digital mode (i.e. the T2-135 is enabled) I regain the
>> remote MIC functions. With it not in digital mode, none of the
>> remote MIC functions except the UP/DOWN buttons work,
>> and DTMF can be sent."
>>
>> It's the same whether you have the stock TNC installed or the T2-135.
>> If you pop the lid again and remove that two conductor cable off to the
>> side of the circuit board, you will regain some of the functions... e.g.
>> you could put it in digital mode and punch a frequency into the keypad,
>> and then take it out of digital mode.
>>
>> 73 es cul - Keith VE7GDH
>> --
>> "I may be lost, but I know exactly where I am!"
>>
>
>   
>

Reply via email to