On Friday 01 February 2008, Stelian Pop wrote: > Le jeudi 31 janvier 2008 à 23:59 +0100, Ulf Samuelsson a écrit : > > > Signed-off-by: Stelian Pop <[EMAIL PROTECTED]> > > > --- > > > board/at91cap9adk/Makefile | 50 +++++++ > > > board/at91cap9adk/at91cap9adk.c | 283 > > > +++++++++++++++++++++++++++++++++++++++ board/at91cap9adk/config.mk > > > | 1 + > > > board/at91cap9adk/led.c | 80 +++++++++++ > > > board/at91cap9adk/nand.c | 71 ++++++++++ > > > board/at91cap9adk/u-boot.lds | 57 ++++++++ > > > > I think it would be better if these files were located in the > > "board/atmel/at91cap9adk", instead of "board/at91cap9adk" > > I did think of that. I have no strong feeling about that. Except that if > we put at91cap9adk under board/atmel, at91rm9200dk should go there too.
Right. I always prefer to "collect" board ports from one manufacturer/brand into a specific directory. This way the board directory doesn't get "polluted" that much. So it would be good if you could provide another patch to move all existing Atmel ports into the board/atmel directory which already exists. Thanks. Best regards, Stefan ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: [EMAIL PROTECTED] ===================================================================== ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ U-Boot-Users mailing list U-Boot-Users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/u-boot-users
