Hi York, > -----Original Message----- > From: york sun > Sent: Thursday, September 08, 2016 10:51 PM > To: Q.Y. Gong <qianyu.g...@nxp.com>; u-boot@lists.denx.de > Cc: Prabhakar Kushwaha <prabhakar.kushw...@nxp.com>; Vincent Hu > <mingkai...@nxp.com>; S.H. Xie <shaohui....@nxp.com>; Z.Q. Hou > <zhiqiang....@nxp.com>; Wenbin Song <wenbin.s...@nxp.com>; Shengzhou > Liu <shengzhou....@nxp.com> > Subject: Re: [Patch v6 8/9] armv8: ls1046ardb: Add LS1046ARDB board support > > On 09/07/2016 03:08 AM, Gong Qianyu wrote: > > From: Mingkai Hu <mingkai...@nxp.com> > > > > LS1046ARDB Specification: > > ------------------------- > > Memory subsystem: > > * 8GByte DDR4 SDRAM (64bit bus) > > * 512 Mbyte NAND flash > > * Two 64 Mbyte high-speed SPI flash > > * SD connector to interface with the SD memory card > > * On-board 4G eMMC > > > > Ethernet: > > * Two XFI 10G ports > > * Two SGMII ports > > * Two RGMII ports > > > > PCIe: > > * PCIe1 (SerDes2 Lane0) to miniPCIe slot > > * PCIe2 (SerDes2 Lane1) to x2 PCIe slot > > * PCIe3 (SerDes2 Lane2) to x4 PCIe slot > > > > SATA: > > * SerDes2 Lane3 to SATA port > > > > USB 3.0: one super speed USB 3.0 type A port > > one Micro-AB port > > > > UART: supports two UARTs up to 115200 bps for console > > The board specification doesn't belong to commit message. Instead, you > can add what features have been supported, such as boot source, any > important commands, special care to prepare the image, etc. >
As such there is no guideline about what should be in commit message of a board support. I request you to guide us with about required things in board support commit message. It will help future board support patches. --prabhakar _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot