On 09/21/2016 12:46 AM, Mingkai Hu wrote: > > >> -----Original Message----- >> From: york sun >> Sent: Saturday, September 17, 2016 4:14 AM >> To: Q.Y. Gong <qianyu.g...@nxp.com>; u-boot@lists.denx.de >> Cc: Prabhakar Kushwaha <prabhakar.kushw...@nxp.com>; Mingkai Hu >> <mingkai...@nxp.com>; S.H. Xie <shaohui....@nxp.com>; Z.Q. Hou >> <zhiqiang....@nxp.com>; Wenbin Song <wenbin.s...@nxp.com>; >> Shengzhou Liu <shengzhou....@nxp.com> >> Subject: Re: [Patch v6 8/9] armv8: ls1046ardb: Add LS1046ARDB board >> support >> >> On 09/07/2016 03:08 AM, Gong Qianyu wrote: >>> From: Mingkai Hu <mingkai...@nxp.com> >>> >>> LS1046ARDB Specification: >>> ------------------------- >>> Memory subsystem: >>> * 8GByte DDR4 SDRAM (64bit bus) >>> * 512 Mbyte NAND flash >>> * Two 64 Mbyte high-speed SPI flash >>> * SD connector to interface with the SD memory card >>> * On-board 4G eMMC >>> >>> Ethernet: >>> * Two XFI 10G ports >>> * Two SGMII ports >>> * Two RGMII ports >>> >>> PCIe: >>> * PCIe1 (SerDes2 Lane0) to miniPCIe slot >>> * PCIe2 (SerDes2 Lane1) to x2 PCIe slot >>> * PCIe3 (SerDes2 Lane2) to x4 PCIe slot >> >> Why don't you enable PCIe in the config file? >> > > A follow up patch will enable PCIe support which will use the SVR to > differentiate some memory map differences > for different silicon.
OK. Thanks. Please note, even I accepted this patch set, it has not been merged due to some upstream changes (specifically ad-hoc config ban). I am working to get them merged. York _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot