On Wed, Mar 1, 2017 at 6:28 PM, Peng Fan <[email protected]> wrote: > Hi Jagan, > > Did you put J3 to connect 1-2?
What is J3, I couldn't find it. I saw J1 PCIe connector and J2 Headphone Jack. Can you point me J3. > > Jumper Boot Selection > 1 - 2 Do not boot from SPI NOR (default) > 2 - 3 Boot from SPI NOR > > >> -----Original Message----- >> From: Jagan Teki [mailto:[email protected]] >> Sent: Wednesday, March 01, 2017 8:56 PM >> To: [email protected] >> Cc: Peng Fan <[email protected]>; Stefano Babic <[email protected]> >> Subject: Re: [U-Boot] i.MX6QP sd boot issue >> >> + ML >> >> On Wed, Mar 1, 2017 at 6:23 PM, Jagan Teki <[email protected]> wrote: >> > Hi Peng and All, >> > >> > I'm trying to boot from SD, on imx6qplus sabre board. >> > >> > - SW6: D1-D8 => 0100 0010 >> > - SD card on SD3 >> > - D12 with USB-to-Serial 115200 8N1 >> > - Power supply Output 5V >> > >> > Build: >> > $ make mx6qpsabreauto_defconfig; make $ dd if=u-boot.imx of=/dev/sda >> > bs=512 seek=2 >> > >> > When I plug-in power, power supply slot D1, D2 are green and D3 glow >> > red not able to get the log on uart. >> > >> > Any help? >> >> thanks! >> -- >> Jagan Teki >> Free Software Engineer | www.openedev.com U-Boot, Linux | Upstream >> Maintainer Hyderabad, India. > > Regards, > Peng. > _______________________________________________ > U-Boot mailing list > [email protected] > http://lists.denx.de/listinfo/u-boot -- Jagan Teki Free Software Engineer | www.openedev.com U-Boot, Linux | Upstream Maintainer Hyderabad, India. _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/listinfo/u-boot
