Enable the following options for the NPCM845 EVB: - CONFIG_CMD_WDT: watchdog control from the console - CONFIG_CMD_GFX - CONFIG_SPI_FLASH_GIGADEVICE: support GigaDevice SPI NOR parts populated on some board revisions - CONFIG_SHA512 / CONFIG_SHA512_HW_ACCEL: SHA512 via the NPCM hardware engine - Enable CONFIG_BOARD_INIT for arbel_evb
Signed-off-by: Jim Liu <[email protected]> --- configs/arbel_evb_defconfig | 7 ++++++- 1 file changed, 6 insertions(+), 1 deletion(-) diff --git a/configs/arbel_evb_defconfig b/configs/arbel_evb_defconfig index fa73f7caf10..cc39ba5b1b0 100644 --- a/configs/arbel_evb_defconfig +++ b/configs/arbel_evb_defconfig @@ -24,7 +24,6 @@ CONFIG_FIT=y CONFIG_FIT_VERBOSE=y CONFIG_USE_BOOTCOMMAND=y CONFIG_BOOTCOMMAND="run common_bootargs; run romboot" -# CONFIG_BOARD_INIT is not set CONFIG_HUSH_PARSER=y CONFIG_SYS_PROMPT="U-Boot>" CONFIG_SYS_MAXARGS=32 @@ -38,6 +37,7 @@ CONFIG_CMD_PART=y CONFIG_CMD_SPI=y CONFIG_CMD_USB=y CONFIG_CMD_USB_MASS_STORAGE=y +CONFIG_CMD_WDT=y CONFIG_CMD_DHCP6=y CONFIG_DHCP6_PXE_DHCP_OPTION=y CONFIG_DHCP6_ENTERPRISE_ID=311 @@ -52,6 +52,7 @@ CONFIG_CMD_UUID=y CONFIG_CMD_HASH=y CONFIG_CMD_TPM=y CONFIG_CMD_EXT4=y +CONFIG_CMD_GFX=y CONFIG_CMD_FAT=y CONFIG_CMD_FS_GENERIC=y CONFIG_ENV_IS_IN_SPI_FLASH=y @@ -64,6 +65,7 @@ CONFIG_NPCM_SHA=y CONFIG_GPIO_HOG=y CONFIG_NPCM_GPIO=y CONFIG_NPCM_SGPIO=y +CONFIG_GPIO_HOG=y CONFIG_DM_I2C=y CONFIG_SYS_I2C_NPCM=y # CONFIG_INPUT is not set @@ -76,6 +78,7 @@ CONFIG_MTD=y CONFIG_DM_SPI_FLASH=y CONFIG_SPI_FLASH_MACRONIX=y CONFIG_SPI_FLASH_WINBOND=y +CONFIG_SPI_FLASH_GIGADEVICE=y # CONFIG_SPI_FLASH_USE_4K_SECTORS is not set CONFIG_PHY_GIGE=y CONFIG_ETH_DESIGNWARE=y @@ -118,4 +121,6 @@ CONFIG_WDT=y CONFIG_WDT_NPCM=y CONFIG_LIB_HW_RAND=y CONFIG_TPM=y +CONFIG_SHA512=y CONFIG_SHA_HW_ACCEL=y +CONFIG_SHA512_HW_ACCEL=y -- 2.34.1
