Faisal etal, I've looped both sides, they act as they should, the fiberPoe gets it's link light and the router is sending and receiving, however when I put fiber between the two devices, I only see Tx packets on the sfp port. obviously the patch cables are ok and the sfp modules are ok, so it must be one of the devices doesn't like something?? I'm at a loss as to what to do / try now.
Regards, Jeff On 9/12/2016 9:46 PM, Jeff Evans wrote: > Should have mentioned, I have this 'labbed' up on living room floor, all > duplicate equipment, save for the router. > > I was wanting to use a single strand, but have more available. > > Tx Power is -3.798 if this is what you are looking for. > > Rx Power is -4.398 > > that is on a short length of fiber (factory jumper) > > > On 9/12/2016 9:28 PM, Faisal Imtiaz wrote: >> some troubleshooting suggestions:- >> >> 1) Take the RB2011 closer to the fiberpoE and test it with a short patch >> cable. >> 2) Create a loop by connecting the far side connectors together and see you >> get link up ? (tough to do with bidi/single strand of fiber). >> 3) invest in an in-expensive light meter ... (approx $50) will do the job. >> 4) can you read light TX & receive levels on the MT ? >> >> BTW what kind of fiber are you using ? >> Based on the optics listed, are you trying to use a single strand of fiber ? >> >> Regards >> >> Faisal Imtiaz >> Snappy Internet & Telecom >> 7266 SW 48 Street >> Miami, FL 33155 >> Tel: 305 663 5518 x 232 >> >> Help-desk: (305)663-5518 Option 2 or Email: [email protected] >> >> ----- Original Message ----- >>> From: "Jeff Evans" <[email protected]> >>> To: "Ubiquiti Users Group" <[email protected]> >>> Sent: Monday, September 12, 2016 8:34:59 PM >>> Subject: [Ubnt_users] RB2011UiAS -- FiberPOE sfp woes >>> I have an RB2011UiAS that I want to use for a customers home router, we >>> have an 800 foot fiber run to a ubnt FiberPOE. Any modules I've tried >>> only show Tx on the Interface, I have also tried the modules on a >>> Netonix switch (replacing the FiberPoe) with the same result. >>> >>> The fiber modules that I have tried : Mikrotik S35LC20D/S53LC20D pair -- >>> MAXXwave MW-1315-SM-US/MW-1513-SM-US pair >>> the above both give me the blue light of success on the >>> FiberPOE but no real joy. >>> >>> AND a set of Maxxwave MW-LX-SM-US -- dual fiber, no light on the >>> FiberPOE with this. >>> >>> any ideas? Thanks! >>> >>> -- >>> Jeff Evans, Managing Member >>> PennWisp, LLC >>> www.pennwisp.com >>> >>> _______________________________________________ >>> Ubnt_users mailing list >>> [email protected] >>> http://lists.wispa.org/mailman/listinfo/ubnt_users >> _______________________________________________ >> Ubnt_users mailing list >> [email protected] >> http://lists.wispa.org/mailman/listinfo/ubnt_users >> -- Jeff Evans, Managing Member PennWisp, LLC www.pennwisp.com _______________________________________________ Ubnt_users mailing list [email protected] http://lists.wispa.org/mailman/listinfo/ubnt_users
