No I don't, it doesn't work with netonix either however
On 9/13/2016 8:43 AM, Faisal Imtiaz wrote: > It is possible that there is some sort of incompatibility.. rare but possible. > since you have it setup as a test lab.. .do you have another RB2011 ? that > you can test with (i.e. 2011 to 2011) ? > > Regards, > > Faisal Imtiaz > Snappy Internet & Telecom > 7266 SW 48 Street > Miami, FL 33155 > Tel: 305 663 5518 x 232 > > Help-desk: (305)663-5518 Option 2 or Email: [email protected] > > ----- Original Message ----- >> From: "Jeff Evans" <[email protected]> >> To: "Ubiquiti Users Group" <[email protected]> >> Sent: Tuesday, September 13, 2016 7:45:49 AM >> Subject: Re: [Ubnt_users] RB2011UiAS -- FiberPOE sfp woes >> Faisal etal, >> >> I've looped both sides, they act as they should, the fiberPoe gets it's >> link light and the router is sending and receiving, however when I put >> fiber between the two devices, I only see Tx packets on the sfp port. >> obviously the patch cables are ok and the sfp modules are ok, so it must >> be one of the devices doesn't like something?? I'm at a loss as to what >> to do / try now. >> >> Regards, Jeff >> >> >> On 9/12/2016 9:46 PM, Jeff Evans wrote: >>> Should have mentioned, I have this 'labbed' up on living room floor, all >>> duplicate equipment, save for the router. >>> >>> I was wanting to use a single strand, but have more available. >>> >>> Tx Power is -3.798 if this is what you are looking for. >>> >>> Rx Power is -4.398 >>> >>> that is on a short length of fiber (factory jumper) >>> >>> >>> On 9/12/2016 9:28 PM, Faisal Imtiaz wrote: >>>> some troubleshooting suggestions:- >>>> >>>> 1) Take the RB2011 closer to the fiberpoE and test it with a short patch >>>> cable. >>>> 2) Create a loop by connecting the far side connectors together and see >>>> you get >>>> link up ? (tough to do with bidi/single strand of fiber). >>>> 3) invest in an in-expensive light meter ... (approx $50) will do the job. >>>> 4) can you read light TX & receive levels on the MT ? >>>> >>>> BTW what kind of fiber are you using ? >>>> Based on the optics listed, are you trying to use a single strand of fiber >>>> ? >>>> >>>> Regards >>>> >>>> Faisal Imtiaz >>>> Snappy Internet & Telecom >>>> 7266 SW 48 Street >>>> Miami, FL 33155 >>>> Tel: 305 663 5518 x 232 >>>> >>>> Help-desk: (305)663-5518 Option 2 or Email: [email protected] >>>> >>>> ----- Original Message ----- >>>>> From: "Jeff Evans" <[email protected]> >>>>> To: "Ubiquiti Users Group" <[email protected]> >>>>> Sent: Monday, September 12, 2016 8:34:59 PM >>>>> Subject: [Ubnt_users] RB2011UiAS -- FiberPOE sfp woes >>>>> I have an RB2011UiAS that I want to use for a customers home router, we >>>>> have an 800 foot fiber run to a ubnt FiberPOE. Any modules I've tried >>>>> only show Tx on the Interface, I have also tried the modules on a >>>>> Netonix switch (replacing the FiberPoe) with the same result. >>>>> >>>>> The fiber modules that I have tried : Mikrotik S35LC20D/S53LC20D pair -- >>>>> MAXXwave MW-1315-SM-US/MW-1513-SM-US pair >>>>> the above both give me the blue light of success on the >>>>> FiberPOE but no real joy. >>>>> >>>>> AND a set of Maxxwave MW-LX-SM-US -- dual fiber, no light on the >>>>> FiberPOE with this. >>>>> >>>>> any ideas? Thanks! >>>>> >>>>> -- >>>>> Jeff Evans, Managing Member >>>>> PennWisp, LLC >>>>> www.pennwisp.com >>>>> >>>>> _______________________________________________ >>>>> Ubnt_users mailing list >>>>> [email protected] >>>>> http://lists.wispa.org/mailman/listinfo/ubnt_users >>>> _______________________________________________ >>>> Ubnt_users mailing list >>>> [email protected] >>>> http://lists.wispa.org/mailman/listinfo/ubnt_users >>>> >> -- >> Jeff Evans, Managing Member >> PennWisp, LLC >> www.pennwisp.com >> >> _______________________________________________ >> Ubnt_users mailing list >> [email protected] >> http://lists.wispa.org/mailman/listinfo/ubnt_users > _______________________________________________ > Ubnt_users mailing list > [email protected] > http://lists.wispa.org/mailman/listinfo/ubnt_users > -- Jeff Evans, Managing Member PennWisp, LLC www.pennwisp.com _______________________________________________ Ubnt_users mailing list [email protected] http://lists.wispa.org/mailman/listinfo/ubnt_users
