Thanks for rthe help. Any suggestions on how to attache wires to ball valves that do not have attachment points? Arew the zincs on the back of the transon considered house bonding plates?
Thanks again On Aug 2, 10:32 pm, "Perry & Cindi" <[email protected]> wrote: > Just a little more explanation, > > use #8 Green TINED wire. The best way is to run separate wires to each piece > of equipment that needs to be bonded. If you have a doubt if it needs to be > bonded, bond it. > > All the wires then goes to a terminal block or several terminal bocks that > ties into your house bonding plate. > > Do not use just one wire connected to a fitting and then going to another > fitting. If there is a brake in any of the connections, you loose all > protection from the brake on, bad, bad. > > You will use a lot of wire but you will be fully protected. Use a GOOD > crimping tool, not the $4.95 crimper special. Also use Marine terminal ends > not cheep automotive ones. You can buy them in bulk to save money. You will > use a lot of terminal ends if you are re-wiring the bonding system on your > boat. > > That's all folks, > > Capt. Perry > > _____ > > From: [email protected] [mailto:[email protected]] > On Behalf Of Rich Zimmerman > Sent: Monday, August 02, 2010 10:23 PM > To: [email protected] > Subject: Re: [UnifliteWorld] Bonding/Cathodic Protection > > Just connect all underwater metals with sz8 wire and terminate on a zinc > plate mounted on the transom. (should be there already) > > Thanks > > _____ > > From: mvcompromise <[email protected]> > To: UnifliteWorld <[email protected]> > Sent: Sat, July 31, 2010 8:04:41 PM > Subject: [UnifliteWorld] Bonding/Cathodic Protection > > Hi All, > > I have a 1982 42' DCMY with 6-71's and looking for some help on the > bonding/cathodic protection. Does anybody have a drawing on the > bonding? Before we bought the boat and over the years wires have come > off thru hulls, rudder post, strut plates and we are noticing > electrolysis starting to development. Any help would be apprecaited. > Thanks, > Red > > -- > You received this message because you are subscribed to the Google Groups > "UnifliteWorld" group. > To post to this group, send email to [email protected]. > To unsubscribe from this group, send email to > [email protected]. > For more options, visit this group > athttp://groups.google.com/group/unifliteworld?hl=en. > > -- > You received this message because you are subscribed to the Google Groups > "UnifliteWorld" group. > To post to this group, send email to [email protected]. > To unsubscribe from this group, send email to > [email protected]. > For more options, visit this group > athttp://groups.google.com/group/unifliteworld?hl=en. -- You received this message because you are subscribed to the Google Groups "UnifliteWorld" group. To post to this group, send email to [email protected]. To unsubscribe from this group, send email to [email protected]. For more options, visit this group at http://groups.google.com/group/unifliteworld?hl=en.
