*And this via dmesg section of the diagnostic page (part 2 of 3) * [ 0.001591] CPU: Testing write buffer coherency: ok [ 0.002059] CPU0: update cpu_capacity 1024 [ 0.002070] CPU0: thread -1, cpu 0, socket 15, mpidr 80000f00 [ 0.002513] Setting up static identity map for 0x100000 - 0x10003c [ 0.002644] Hierarchical SRCU implementation. [ 0.003332] smp: Bringing up secondary CPUs ... [ 0.004144] CPU1: update cpu_capacity 1024 [ 0.004152] CPU1: thread -1, cpu 1, socket 15, mpidr 80000f01 [ 0.005043] CPU2: update cpu_capacity 1024 [ 0.005051] CPU2: thread -1, cpu 2, socket 15, mpidr 80000f02 [ 0.005891] CPU3: update cpu_capacity 1024 [ 0.005897] CPU3: thread -1, cpu 3, socket 15, mpidr 80000f03 [ 0.005997] smp: Brought up 1 node, 4 CPUs [ 0.006007] SMP: Total of 4 processors activated (153.60 BogoMIPS). [ 0.006011] CPU: All CPU(s) started in HYP mode. [ 0.006015] CPU: Virtualization extensions available. [ 0.006918] devtmpfs: initialized [ 0.016038] VFP support v0.3: implementor 41 architecture 2 part 30 variant 7 rev 5 [ 0.016288] clocksource: jiffies: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 19112604462750000 ns [ 0.016308] futex hash table entries: 1024 (order: 4, 65536 bytes) [ 0.016925] pinctrl core: initialized pinctrl subsystem [ 0.017727] NET: Registered protocol family 16 [ 0.020304] DMA: preallocated 1024 KiB pool for atomic coherent allocations [ 0.024600] hw-breakpoint: found 5 (+1 reserved) breakpoint and 4 watchpoint registers. [ 0.024610] hw-breakpoint: maximum watchpoint size is 8 bytes. [ 0.024806] Serial: AMBA PL011 UART driver [ 0.026360] bcm2835-mbox 3f00b880.mailbox: mailbox enabled [ 0.054471] bcm2835-dma 3f007000.dma: DMA legacy API manager at be813000, dmachans=0x1 [ 0.055814] SCSI subsystem initialized [ 0.056046] usbcore: registered new interface driver usbfs [ 0.056096] usbcore: registered new interface driver hub [ 0.056196] usbcore: registered new device driver usb [ 0.060274] raspberrypi-firmware soc:firmware: Attached to firmware from 2018-03-14 16:51 [ 0.061672] clocksource: Switched to clocksource arch_sys_counter [ 0.120623] VFS: Disk quotas dquot_6.6.0 [ 0.120709] VFS: Dquot-cache hash table entries: 1024 (order 0, 4096 bytes) [ 0.120919] FS-Cache: Loaded [ 0.121160] CacheFiles: Loaded [ 0.130018] NET: Registered protocol family 2 [ 0.130724] TCP established hash table entries: 8192 (order: 3, 32768 bytes) [ 0.130813] TCP bind hash table entries: 8192 (order: 4, 65536 bytes) [ 0.130939] TCP: Hash tables configured (established 8192 bind 8192) [ 0.131081] UDP hash table entries: 512 (order: 2, 16384 bytes) [ 0.131131] UDP-Lite hash table entries: 512 (order: 2, 16384 bytes) [ 0.131383] NET: Registered protocol family 1 [ 0.131957] RPC: Registered named UNIX socket transport module. [ 0.131965] RPC: Registered udp transport module. [ 0.131969] RPC: Registered tcp transport module. [ 0.131973] RPC: Registered tcp NFSv4.1 backchannel transport module. [ 0.132225] Trying to unpack rootfs image as initramfs... [ 0.457712] Freeing initrd memory: 4588K [ 0.462855] hw perfevents: enabled with armv7_cortex_a7 PMU driver, 5 counters available [ 0.465639] workingset: timestamp_bits=14 max_order=18 bucket_order=4 [ 0.472790] FS-Cache: Netfs 'nfs' registered for caching [ 0.473439] NFS: Registering the id_resolver key type [ 0.473477] Key type id_resolver registered [ 0.473481] Key type id_legacy registered [ 0.475400] Block layer SCSI generic (bsg) driver version 0.4 loaded (major 251) [ 0.475539] io scheduler noop registered [ 0.475545] io scheduler deadline registered (default) [ 0.475815] io scheduler cfq registered [ 0.475822] io scheduler mq-deadline registered [ 0.475827] io scheduler kyber registered [ 0.477653] BCM2708FB: allocated DMA memory fdd00000 [ 0.477689] BCM2708FB: allocated DMA channel 0 @ be813000 [ 0.482196] Console: switching to colour frame buffer device 82x26 [ 0.486019] bcm2835-rng 3f104000.rng: hwrng registered [ 0.486136] vc-mem: phys_addr:0x00000000 mem_base=0x3f000000 mem_size:0x3f600000(1014 MiB) [ 0.486576] vc-sm: Videocore shared memory driver [ 0.486856] gpiomem-bcm2835 3f200000.gpiomem: Initialised: Registers at 0x3f200000 [ 0.497078] brd: module loaded [ 0.505657] loop: module loaded [ 0.505671] Loading iSCSI transport class v2.0-870. [ 0.506379] libphy: Fixed MDIO Bus: probed [ 0.506465] usbcore: registered new interface driver lan78xx [ 0.506516] usbcore: registered new interface driver smsc95xx [ 0.506532] dwc_otg: version 3.00a 10-AUG-2012 (platform bus) [ 0.734665] Core Release: 2.80a [ 0.734675] Setting default values for core params [ 0.734709] Finished setting default values for core params [ 0.934934] Using Buffer DMA mode [ 0.934940] Periodic Transfer Interrupt Enhancement - disabled [ 0.934945] Multiprocessor Interrupt Enhancement - disabled [ 0.934950] OTG VER PARAM: 0, OTG VER FLAG: 0 [ 0.934965] Dedicated Tx FIFOs mode [ 0.935398] WARN::dwc_otg_hcd_init:1046: FIQ DMA bounce buffers: virt = 0xbdd14000 dma = 0xfdd14000 len=9024 [ 0.935424] FIQ FSM acceleration enabled for :
------------------------------------------------------------------------ marflao's Profile: http://forums.slimdevices.com/member.php?userid=57334 View this thread: http://forums.slimdevices.com/showthread.php?t=109404 _______________________________________________ unix mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/unix
