Dear Matic I also tried the same procedure on other pc but I am getting error libtcl8.5.dll not found. Installling how can I install libtcl8.5. I have installed tcl-tk8.5 package but no libtcl8.5 file is there in cygwin directory, instead there is libtcl8.6. Where I can find libtcl8.5.dll?
On Sun, Jul 23, 2017 at 9:07 AM, Rajesh <[email protected]> wrote: > Dear Matic > I repeated the steps as: > First I removed cygwin fully and installed it again. Then > > 1. installed everything as you mentioned. > 2. Issued the command XWin :0 -clipboard -multiwindow & xterm & > 3. Open another cygwin terminal and issued ./xcrysden from xcrysden top > directory. > 4. But no luck. Still giving the same issue. > > Thanks. > > > On Sat, Jul 22, 2017 at 10:37 PM, Matic Poberžnik < > [email protected]> wrote: > >> Dear Rajesh, >> >> I just installed it on my system and it seems to work (Windows 7 but I >> think there shouldn't be much difference): >> >> First I installed the dependencies: >> >> apt-cyg install libGL1 libGLU1 xorg-server bash bc coreutils gawk >> grep gzip ImageMagick less libgfortran3 xterm >> >> >> (libgfortran3 is needed to avoid some errors) >> Then I started x by typing (I get similar messages than you but they >> shouldn't be anything to worry about): >> >> XWin :0 -clipboard -multiwindow & >> xterm & >> >> This started the xterm, from which I was then able to run from the top >> install directory xcrysden (~/xcrysden-1.5.60-bin-shared/). >> >> ./xcrysden >> >> So in the end I am unable to reproduce your problem, could you try these >> steps and let me know how it goes? >> >> Best Regards, >> >> Matic Poberznik >> J. Stefan Institute, Jamova 39, 1000 Ljubljana, Slovenia >> >> >> >> 2017-07-22 15:41 GMT+02:00 Rajesh <[email protected]>: >> >>> Dear Matic >>> Its not starting even from xterminal. When I start startx I get some >>> errors >>> (II) xorg.conf is not supported >>> and LoadPreferences: /home/RAMJI/.XWinrc not found >>> >>> >>> On Sat, Jul 22, 2017 at 7:31 PM, Matic Poberznik < >>> [email protected]> wrote: >>> >>>> >>>> >>>> > But dont get any xcrysden window. >>>> >>>> I'm not sure it seems everything should be ok. Are you sure you started >>>> it from the xterminal? >>>> i.e. after typing startx a new terminal should appear, and xcrysden >>>> should work from there. >>>> >>>> >>>> Best Regards, >>>> >>>> Matic >>>> -- >>>> Matic Poberznik >>>> J. Stefan Institute, Jamova 39, 1000 Ljubljana, Slovenia >>>> >>> >>> >> >
_______________________________________________ Pw_forum mailing list [email protected] http://pwscf.org/mailman/listinfo/pw_forum
