2012/10/8 Fabian Deutsch <fabi...@redhat.com> > Hey, > > Am Sonntag, den 07.10.2012, 15:29 +0100 schrieb Alexandre Santos: > > Hi, > > I'm trying to install the ovirt-node iso image on a SATA disk and when > > it gets to the screen where it shows 25% completed the kernel hangs. I > > can't connect using a serial console to see what has happened. If I > > reboot using a usb linux disk I see that the SATA disk has been > > formated and the partitions that existed before disappeared, being > > there just one partition of type "ee" > > Is there any error displayed when kernel hangs at 25%? And it can take > some time to pass the 25% (up to ~2min or so). >
No, I think it's a kernel hang because the lights on the keyboard halt and I can't change to tty2, etc.. I even changed to tty2 and waited to see if there were some errors but nothing. I've read that "tty8" was the logging console but no luck also. BTW, I tried with an IDE disk and the result was the same. > > > If I use a 8 GB usb pen-drive instead of the SATA disk, the > > installation comes to an end and I reboot but then I get some error > > about not getting /dev/mapper/by-name/Root and the boot fails to a > > dracut shell. > > Any ideas? > > In the dracut shell, could you run blkid and post the results? > I noticed that the USB Disk was named RootBackup instead of Root... I then rebooted and chose uninstall and then installed oVirt Node from scratch and now it worked. I can't activate Networking because I have that "no hostname" error mentioned in another post. I think it's related to that... > > Greetings > fabian >
_______________________________________________ Users mailing list Users@ovirt.org http://lists.ovirt.org/mailman/listinfo/users
