Hello Strahil,I follow the guide in "Installing oVirt as a self-hosted engine 
using the Cockpit web interface". Only 1 host and 1 SAS storage. Host and 
storage are direct attached. CentOS 8 was installed in host local disk.Only 1 
SAS cable connected. So I think shouldn't be the issue of Multipath.


    2020年8月7日金曜日 20:37:47 GMT+8、Strahil Nikolov <hunter86...@yahoo.com>が書いたメール: 
 Are you using the single-node wizard  ?

Best Regards,
Strahil Nikolov

На 7 август 2020 г. 11:34:52 GMT+03:00, hkexdong--- via Users <users@ovirt.org> 
>I've an external RAID subsystem connect to the host by SAS cable
>I follow the instructions of the RAID card manufacture. Include the
>driver during host installation. And I can see the created RAID volumes
>(LUNs) available in "Installation Destination". Although I choose to
>install the engine in host local disk.
>The installation success and I proceed to hosted engine deployment by
>Cockpit. And now I stuck at part 4 Storage.
>I believe "Storage Type" select "Fibre Channel" is correct even I'm not
>using fibre cable. As NFS and iSCSI are utilize network.
>I confirm there are 2 RAID volume (LUN0 & LUN1) created in the external
>RAID subsystem. Why oVirt cannot discover them. What could be wrong :(
>Users mailing list -- users@ovirt.org
>To unsubscribe send an email to users-le...@ovirt.org
>Privacy Statement: https://www.ovirt.org/privacy-policy.html
>oVirt Code of Conduct:
>List Archives:
Users mailing list -- users@ovirt.org
To unsubscribe send an email to users-le...@ovirt.org
Privacy Statement: https://www.ovirt.org/privacy-policy.html
oVirt Code of Conduct: 
List Archives: 

Reply via email to