"Bill D. Miller" wrote:
> But this is: how do you
> relate the measurement of the hole you drilled to a jet size? Seems like
> everyone has a different rationale for sizing jets --none based on simple
> diameter in an accepted standard measurement system (metric, english). Can
> you just call Mikuni -- tell them you need a PAJ#2 with a .004" hole and
> have them send you four?
>
It's really easy. All you need is a "numbered" drill set 1 to 60 is the
norm. Mikuni jet sizes are typically a metric equivelant of a mm. For
instance a 160 jet would typically be 1.6 mm or about .070 inches. This has
always been the case with every mikuni I have ever worked on. I have not done
the Max carbs this way.....didn't have too but I would not hesitate to do so if
I had major changes to do. Good luck!
--
===============================================
Paul Sayegh
V-Max Technical List Administrator
VMOA Northwest Director
V-Max web page http://www.sayegh.org/tips.htm
===============================================
.............................................
To unsubscribe go to http://www.sayegh.org/unsubscribe.htm
.............................................
