G'Day Alex, > 1) > I had to 'chown root.root /home/vpopmail/bin/vchkpw'.
Will check this. > 2) Also, try this: > > make the 'authmodulelist=' line in > /usr/local/sqwebmail/authdaemonrc look like: > authmodulelist="authvchkpw" > > Because I think sqwebmail gets confused if authvchkpw is not first in the > list, as earlier entries take precedence for authorization, and any othe > authmodules you may have compiled may be complicating the situation. See > next suggestion. Not even worrying about sqwebmail at the moment. Normal popping in doesn't work, so i didn't even get that far as to test the sqwebmail part.. > 3) > > /usr/local/src/vpopmail-5.2.1# ./configure --help |grep sqwebmail : > " --enable-sqwebmail-pass=y|n Turn on support for sqwebmail passwords (y) > or off (n) default is no. For sqwebmail-3.0 and above use default no" > Hmm? > > Try to explicitly set all configure options, especially auth options for > both sqwebmail and vpopmail: Again not even worried about the sqwebmail part yet.. > /usr/local/src/vpopmail-5.2.1# ./configure --help > /usr/local/src/sqwebmail-184.108.40.20621223# ./configure --help > > like for sqwebmail: > ./configure --with-(only module you need probably > authvchkpw) --without-(everything you dont need) > and etc for vpopmail. > > These suggestions may help. Please let me know if they do. > > [EMAIL PROTECTED] Regards Nathan > > ----- Original Message ----- > >From: "Nathan Chan" <[EMAIL PROTECTED]> > >To: <[EMAIL PROTECTED]> > >Sent: Monday, December 30, 2002 4:57 PM > >Subject: [vchkpw] Upgrading Vpopmail to 5.2.1 and Auth Now Fails > > > > >G'Day All, > > > >I have had a stable and working qmail + vpopmail + qmailadmin + > >sqwebmail system running for some 2 years now except for one > >little prob under sqwebmail for quota's. Upon reading some info i > >believe this quirk is now gone under sqwebmail in the new versions > >but to do that upgrade of course i need to upgrade vpopmail, which > >was fine, except that the new version won't auth anyone with the > >new vchkpw... > > > >Info for system below : > >Qmail 1.03 (of course) > >vpopmail-3.4.11-1 > > > >my configure line for the new vpopmail (5.2.1) is : > >./configure --enable-ip-alias-domains=y --enable-logging=e --enable- > >vpopuser=vpopmail --enable-md5-passwords=y --enable- > >defaultquota=20M --enable-clear-passwd=n > > > >(i have tried with enable-clear-passwd=y but no difference.) > > > >I run Qmail under tcpserver as follows : > >tcpserver -R -H 0 pop3 /var/qmail/bin/qmail-popup > >domainxyz.com.au /home/vpopmail/bin/vchkpw /var/qmail/bin/qmail- > >pop3d Maildir& > > > >The domains all have their vpasswd/vpasswd.cdb files, but for some > >reason when i update the vchkpw it fails to auth. As soon as i > >revert no probs. > > > >Any help would be greatly appreciated. > > > >Thanks > >Nathan > > > > > >Out the 100TX, through the switch, down the cable modem, over the fiber > >optics, off the bridge, past the head end office.... nothing but 'Net. > > > > > > > > > > >