The network type should be bridged. I'd remove host-only and NAT if you
have them enabled for simplicity.
How are the Virtual Switch 1 & 2 values configured in the VM profile?
On the Summary page for the VMware host, what is listed under the Name
column under Networks? For VMware Server 2.x, the defaults are usually
"Bridged" and "Bridged (2)". Configure your VCL VM profile values to
match the values in the Name column, not the VMnet column.
Also, check the subnet mask and default gateway being assigned to your
images. Can you ping the default gateway?
-Andy
On 1/24/2011 2:12 PM, James Patrick Sigmon wrote:
Hey all,
I'm having troubles getting internet access for my images. I'm currently
assigning address statically on a standalone system. The images can
communicate with each other and the management node, but nothing outside of
that. I confirmed with the network guys that the ip addresses I'm using should
have internet access, so I assume this must be a VMware setting issue.
This is my first time using VMware Server 2, so I may have slipped up
somewhere. I've tried host-only and bridged networking and neither resolve the
issue. In the past, for VMware Server 1, I used to use Custom and then
specified the vmnet. I'm not sure how this setting transposes over to VMware
Server 2.
Any ideas are appreciated.
Thanks,
Patrick Sigmon
