Am 29.06.2010 20:36, schrieb Timothy D. Lenz:
The problem is, it doesn't properly change the entry. This is the
summary for the timer as it first sets up:
And just changing the channel, it does this:
This "<channel>" entry is just for information and is not used in the
epgsearch tries to simulate all future recordings in its conflict check.
It checks if your devices are able to record the timers channel at the
given time. This is done by 'simply' using the same algorithm as VDR
when it has to decide what device should be used for a recording at the
timer start. So even things like working CAMs are checked.
Perhaps you could enable verbose logging to see the single steps of the
-P'epgsearch -v 3'
Another problem I've run into, vdradmin only allows you to set a flat
total number of dvb cards. It doesn't allow for the fact that not all
the cards are the same. I had a second dual atsc tuner which went bad
and will be replaced. So right now I have 2 tuners, but only 1 of each
time and will have 4, but again, only 1 is sat.
as far as I know, vdradmin uses epgsearch's conflict check. epgsearch
itself determines the available devices and their properties and
supported sources with the same means as VDR itself.
Some of this maybe a problem with epgsearch plugin since that is where
the search and auto timer setups is done.
So a mix of different cards and different sources should be no problem.
vdr mailing list