That depends on the way you entered XEDIT for each. If you did it by typing the xedit command on the command line, then a simple XEDIT (can be abbreviated X) on the command line will cycle you through them; X fn ft will jump to that member of the XEDIT ring. If you used FILELIST, RDRLIST, MACLIST, etc., for any but the first, then you are out of luck. Each one of those commands starts its own ring and you cannot use the XEDIT command to traverse from one ring to another.
Regards, Richard Schuh -----Original Message----- From: VM/ESA and z/VM Discussions [mailto:[EMAIL PROTECTED] On Behalf Of Edward M. Martin Sent: Friday, February 17, 2006 1:27 PM To: [email protected] Subject: A usage question Hello Everyone, When I am xediting a member, I may have jumped into 2 or 3 members. Is there a way to rotate to each member with getting out of each? Can I jump to a specific member? Thanks, Ed Martin Aultman Health Foundation 330-588-4723 [EMAIL PROTECTED] ext. 40441
