Hello and Thanks to Richard Schuh and Dave Jones Ed Martin Aultman Health Foundation 330-588-4723 [EMAIL PROTECTED] ext. 40441
>> -----Original Message----- >> From: VM/ESA and z/VM Discussions [mailto:[EMAIL PROTECTED] On >> Behalf Of Dave Jones >> Sent: Friday, February 17, 2006 5:16 PM >> To: [email protected] >> Subject: Re: A usage question >> >> Snag the INFOLIST package off of the IBM VM download page >> (http://www.vm.ibm.com/download/packages/). It's a replacement for >> FILE LIST, MACLIST and RDRLIST with a lot of handy features. You can >> cycle through all of your files in a XEDIT session, regardless of how >> you got there. YMMY. >> >> DJ >> >> Schuh, Richard wrote: >> > That depends on the way you entered XEDIT for each. If you did it by >> > typing the xedit command on the command line, then a simple XEDIT >> > (can be abbreviated X) on the command line will cycle you through >> > them; X fn ft will jump to that member of the XEDIT ring. If you used >> > FILELIST, RDRLIST, MACLIST, etc., for any but the first, then you are >> > out of luck. Each one of those commands starts its own ring and you >> > cannot use the XEDIT command to traverse from one ring to another. >> > >> > Regards, Richard Schuh >> > >> > -----Original Message----- From: VM/ESA and z/VM Discussions >> > [mailto:[EMAIL PROTECTED] On Behalf Of Edward M. Martin >> > Sent: Friday, February 17, 2006 1:27 PM To: VMESA- >> [EMAIL PROTECTED] >> > Subject: A usage question >> > >> > Hello Everyone, >> > >> > When I am xediting a member, I may have jumped into 2 or 3 members. >> > Is there a way to rotate to each member with getting out of each? >> > >> > Can I jump to a specific member? >> > >> > Thanks, >> > >> > Ed Martin Aultman Health Foundation 330-588-4723 [EMAIL PROTECTED] >> > ext. 40441
