Jack-- In the following link to the resistance wire plot (http://www.lenr-coldfusion.com/wp-content/uploads/2015/01/exp5resistance.png) it appears that the resistance of the controls heater wire did not change. Was the temperature of the control constant? It would be desirable to display the time as well as the resistance to understand the input power as well as the temperatures. And how was the resistance determined? Was it calculated from a measurement of voltage and current? I assume this was the case. Were both resistances of the control and the loaded experiment determined in the same manner? Are you sure the PC connections with the incoming signals recording the resistance were sound? You might want to swap instrument leads around to confirm the connections are all ok.
You also refer to a decrease in temperature at about 25,000 sec. into the run to have been caused by opening the "tube furnace" What is the purpose of the "tube furnace" in your experiment? Was this furnace also heated to provide an external heat source to the reaction tube, which I understand was heated internally with the resistance heating wire? If I missed an earlier description of your experiment, please excuse my questions and comments. Bob ----- Original Message ----- From: Axil Axil To: vortex-l Sent: Saturday, January 17, 2015 8:31 PM Subject: Re: [Vo]:A strange and screwy claim by Piantelli http://www.lenr-coldfusion.com/2015/01/13/hot-cat-replication-attempt/ see power drops near 3393 and 3499, but output temperature stays constant. On Sat, Jan 17, 2015 at 9:40 PM, <mix...@bigpond.com> wrote: In reply to Axil Axil's message of Sat, 17 Jan 2015 21:17:13 -0500: Hi, [snip] >If you have noted, at the far end of Jack Cole's temperature curve, the >power feed to the heater is still fluctuating but the temperature of the >reactor stays constant. Has LENR gain set in? I think so. Which temperature curve are you referring to? > >On Sat, Jan 17, 2015 at 9:08 PM, <mix...@bigpond.com> wrote: > >> In reply to Jack Cole's message of Sat, 17 Jan 2015 16:47:13 -0600: >> Hi, >> [snip] >> >Axil, >> > >> >You may find a plot of a the resistance during the successful run vs. the >> >control run to be of interest. >> > >> > >> http://www.lenr-coldfusion.com/wp-content/uploads/2015/01/exp5resistance.png >> > >> >Best, >> >Jack >> >> Fast particles interacting with the resistance coil will produce many more >> ion/electron pairs in the metal, and cause the resistance to drop. >> >> Regards, >> >> Robin van Spaandonk >> >> http://rvanspaa.freehostia.com/project.html >> >> Regards, Robin van Spaandonk http://rvanspaa.freehostia.com/project.html
