Don;t know what all the fuss is about. It easy enough to look at the signal with a good oscilloscope and see if there is likely to be a problem. Seems to me the skeptics are busy looking for exotic ways to cheat so they can console themselves that it doesn't work even if me356's reactor actually does work. Considering its ancestry I don't know know why Brian hasn't said it should be colored purple. MFMP seem a competent bunch and short of seeing the actual test I have no reason to doubt their results.
-----Original Message----- From: Bob Higgins <[email protected]> To: vortex-l <[email protected]> Sent: Thu, May 25, 2017 3:39 pm Subject: [Vo]: MFMP starting to test me356 reactor today I do not believe the Aura device is a plasma electrolysis system. I believe it is a Ni-H system with a dry reactor that is electrically stimulated. The water is from cooling of the reactor. MFMP will be measuring wall plug power as the input to the Aura device with two different power analyzers. The wall plug power should not be as hard to measure as plasma electrolysis input power. I agree that there are serious issues with measuring the power of a plasma electrolysis system by measuring voltage and current. With the bubbles popping up and instantly changing the cell voltage and current, it doesn't surprise me in the least that ultrasound and low RF signals are detected. I also agree that measuring steam accurately is an issue. However, measuring steam via heat exchanger or by sparging the steam is conservative - if anything it will report less energy than actually exists in the steam (with any entrained hot water). Thus, the COP measured would be lower than the actual device is producing. On Thu, May 25, 2017 at 6:24 AM, Brian Ahern <[email protected]> wrote: May I make a prediction? When the COP is around 6-8 and the process is plasma electrolysis, the input is invariably under reported. The plasma is actually a series of sporadic arcs. Measuring the I(t) and V(t) simultaneously is impossible for all but the most sophisticated test equipment. If the plasma electrolysis is not in operation, but boiling is; then we face the issue of dry versus wet steam which causes errors consonant with a COp around 6-8. From: Adrian Ashfield <[email protected]> Sent: Thursday, May 25, 2017 3:53 AM To: [email protected] Subject: [Vo]: MFMP starting to test me356' reactor today Four members of MFMP are in Czechoslovakia and starting to do a black box test of me356' reactor. It is supposed to be similar to his previous model that has been running several months now. It was reported to be ~10 Kw with a COP >6. See http://www.e-catworld.com/2017/05/23/mfmp-on-site-preparing-for-me356-testing/
