Oops. I think the specs on page 60 pertain only a much large hypothetical configuration. I think the engineering firms BLP has contracted with may attempt to construct a prototype more akin to the specs on page 78. Presumably, this is a much smaller, less ambitious configuration. I'm guessing this configuration would more closely match the specs on page 59.
. . . . . You can view some of the specs at the following PDF file: http://www.blacklightpower.com/wp-content/uploads/pdf/Abbreviated_Business_P resentation-8-2014.pdf On page 59: Operating Specifications: Ignition current 10k A to 30kA Ignition Voltage 4.5 V - 15V System Peak Input Power 45 kW to 450 kW ... and on page 60, the Operating specifications of an alleged 10 MW electric SunCell generator with a rotary ignition-regeneration and Optical Distribution and Potovoltaic Converter System. Ignition current: 20k A to 30k A Ignition voltage: 4.5 V 8 8 V. System Peak Input Power: 90 kW to 240 kW ... presumably to be delivered... Regards, Steven Vincent Johnson svjart.orionworks.com zazzle.com/orionworks From: David Roberson [mailto:[email protected]] Sent: Saturday, August 23, 2014 12:00 PM To: [email protected] Subject: Re: [Vo]:SunCell - Better Design Possibilities? The material through which the current flows determines the voltage appearing across its terminals. This can be adjusted over a significant range by playing with the geometry of the structure. If magnetic fields enter into the equation then it is important to make the trade off such that the current is increased at the expense of voltage. I am under the impression that Mills uses the large current to enhance his reaction and goes to a lot of effort to achieve that goal. Dave -----Original Message----- From: Axil Axil <[email protected]> To: vortex-l <[email protected]> Sent: Sat, Aug 23, 2014 12:20 pm Subject: Re: [Vo]:SunCell - Better Design Possibilities? The important factor is instansious power(IP). High amperage can produce the required level of IP, or high voltage can, or the duration of the pulse can be shortened. To get the best COP, a very high voltage pulse...say 5 million volts, that is pulsed for under a nanosecond will provide the required results with the best COP. On Sat, Aug 23, 2014 at 11:22 AM, Orionworks - Steven Vincent Johnson <[email protected]> wrote: In case it was missed, Dr. Mills mentions the fact that they use a huge amount of amperage to generate the explosion. Voltage, OTOH, is extremely low. I assume this is not a normal configuration spot welder equipment uses. Regards, Steven Vincent Johnson svjart.orionworks.com zazzle.com/orionworks
