Hi Punky, After seing the result of ifconfig, i also had some suspicion about DHCP. But then, earlier today (about 4h ago) I booted the very same box with Voyage 0.5.2, in the very same position, with the very same ethernet cable, connected to the very same router. And i tried booting the 0.6.1 version at least twice. I thus, doubt that it is a DHCP problem. But if you want me to, i can try to boot again with 0.5.2.
Maybe it would be easier to start from Voyage 0.5.2? I couldn't figure out how to customize it though. Cheers, Max. On Wed, Jun 24, 2009 at 2:38 AM, Kim-man 'Punky' TSE <[email protected]>wrote: > Hi Max, > > From ifconfig, eth0 should be the network interface. It is just that eth0 > is not started or failed in getting DHCP lease? > > Something a bit strange is that eth0 should use IRQ15 but I can't find it > in /proc/interrupts. > > Regards, > Punky > > Max Bridgewater wrote: > >> Hi Punky, >> >> Attached are three documents with the result of each of these commands. >> >> Ad Sean: curious to know which version of Voyage are you running? I've >> never tried the CF because my notebook doesn't support one. >> >> Thanks again, >> Max. >> >> On Wed, Jun 24, 2009 at 2:10 AM, Kim-man 'Punky' TSE < >> [email protected] <mailto:[email protected]>> wrote: >> >> Hi Max, >> >> I see r6040 driver is loaded via udev. Please show me the output >> of the following: >> 1. lspci -v >> 2. ifconfig -a >> 3. cat /proc/interrupts >> >> - Punky >> >> > > -- > Regards, > Punky > > Voyage Solutions (http://solution.voyage.hk) > * Embedded Solutions and Systems > - Mesh Networking, Captive Portal, IP Surveillance, VoIP/PBX > - Network Engineering, Development Platform and Consultation > > >
_______________________________________________ Voyage-linux mailing list [email protected] http://list.voyage.hk/mailman/listinfo/voyage-linux
