Hi Max,
So it most probably relates to a problem in r6040 driver of the 2.6.26
kernel. If you switched to 0.5.2, please post the output of dmesg,
lspci -v, cat /proc/interrupts and ifconfig -a.
Regards,
Punky
Max Bridgewater wrote:
ifpu eth0 says: Ignoring unknown interface eth0=eth0.
Max.
On Wed, Jun 24, 2009 at 3:04 AM, Kim-man 'Punky' TSE
<[email protected] <mailto:[email protected]>> wrote:
Hi Max,
My analysis is still not conclusive.
Before you switch to 0.5.2, try "ifup eth0" to see if you can
bring up eth0 and function properly.
Regards,
Punky
Max Bridgewater wrote:
Hi Punky,
After seing the result of ifconfig, i also had some suspicion
about DHCP. But then, earlier today (about 4h ago) I booted
the very same box with Voyage 0.5.2, in the very same
position, with the very same ethernet cable, connected to the
very same router. And i tried booting the 0.6.1 version at
least twice. I thus, doubt that it is a DHCP problem. But if
you want me to, i can try to boot again with 0.5.2.
Maybe it would be easier to start from Voyage 0.5.2? I
couldn't figure out how to customize it though.
Cheers,
Max.
On Wed, Jun 24, 2009 at 2:38 AM, Kim-man 'Punky' TSE
<[email protected] <mailto:[email protected]>
<mailto:[email protected] <mailto:[email protected]>>>
wrote:
Hi Max,
>From ifconfig, eth0 should be the network interface. It
is just
that eth0 is not started or failed in getting DHCP lease?
Something a bit strange is that eth0 should use IRQ15 but I
can't
find it in /proc/interrupts.
Regards,
Punky
Max Bridgewater wrote:
Hi Punky,
Attached are three documents with the result of each of
these
commands.
Ad Sean: curious to know which version of Voyage are you
running? I've never tried the CF because my notebook
doesn't
support one.
Thanks again,
Max.
On Wed, Jun 24, 2009 at 2:10 AM, Kim-man 'Punky' TSE
<[email protected] <mailto:[email protected]>
<mailto:[email protected] <mailto:[email protected]>>
<mailto:[email protected]
<mailto:[email protected]> <mailto:[email protected]
<mailto:[email protected]>>>>
wrote:
Hi Max,
I see r6040 driver is loaded via udev. Please show
me the
output
of the following:
1. lspci -v
2. ifconfig -a
3. cat /proc/interrupts
- Punky
-- Regards,
Punky
Voyage Solutions (http://solution.voyage.hk)
* Embedded Solutions and Systems
- Mesh Networking, Captive Portal, IP Surveillance, VoIP/PBX
- Network Engineering, Development Platform and Consultation
--
Regards,
Punky
Voyage Solutions (http://solution.voyage.hk)
* Embedded Solutions and Systems
- Mesh Networking, Captive Portal, IP Surveillance, VoIP/PBX
- Network Engineering, Development Platform and Consultation
--
Regards,
Punky
Voyage Solutions (http://solution.voyage.hk)
* Embedded Solutions and Systems
- Mesh Networking, Captive Portal, IP Surveillance, VoIP/PBX
- Network Engineering, Development Platform and Consultation
_______________________________________________
Voyage-linux mailing list
[email protected]
http://list.voyage.hk/mailman/listinfo/voyage-linux
