Paul,
According to the System profiler one is set to 0 and the other was
set to 7....might need to check that
Where does one find the jumper setting.
JOhn
On the SCSI drive there will be 3 pairs of pins used to choose a
number between 0 and 7 (in binary). Note that you shouldn't use 0 as
that's reserved for the computer itself.
So, the drives can be
0 - 000
1 - 001
2 - 010
3 - 011
4 - 100
5 - 101
6 - 110
7 - 111
Where 0 represents 'no jumper' and 1 represents a jumper across a
pair of pins. You can find which pins are used to select the address
by finding the drive's manual on the internet, or looking on the
drive itself for some documentation or a diagram.
You need to make sure that everything on the same SCSI bus has a
different number.
Have fun,
Shay
--
=========================== Shay Telfer ================================
Perth, Western Australia Technomancer Join Team Sungroper, race the
Opinions for hire [POQ] 2003 World Solar Challenge
[EMAIL PROTECTED] fnord <http://sungroper.asn.au/>
