As a ‘known good’ I will try if my data fails.
On Tue, Sep 4, 2018 at 11:41 PM Colin Larsen <[email protected]> wrote: > I guess as another test if needed, you could just connect to my feed and > read my data into your page too > > On Wed, Sep 5, 2018 at 3:40 PM G Hammer <[email protected]> wrote: > >> Yep, I’ll just swap to the test server. >> Thanks >> >> On Tue, Sep 4, 2018 at 11:38 PM Colin Larsen <[email protected]> >> wrote: >> >>> You may need to change unit_system to match yours is all >>> >>> On Wed, 5 Sep 2018, 15:25 G Hammer, <[email protected]> wrote: >>> >>>> Thanks. >>>> I’ll swap to test tomorrow. >>>> >>>> >>>> It’s always something... >>>> >>>> >>>> On Tue, Sep 4, 2018 at 11:01 PM Colin Larsen <[email protected]> >>>> wrote: >>>> >>>>> Here's mine that work fine >>>>> >>>>> >>>>> Weewx.conf >>>>> >>>>> [[MQTT]] >>>>> >>>>> #This section is for the MQTT service setup >>>>> >>>>> server_url = mqtt://test.mosquitto.org:1883/ >>>>> >>>>> topic = weather/41south >>>>> >>>>> unit_system = METRIC >>>>> >>>>> binding = archive, loop >>>>> >>>>> aggregation = aggregate >>>>> >>>>> Skin.conf >>>>> >>>>> >>>>> # MQTT Defaults >>>>> >>>>> mqtt_enabled = 1 >>>>> >>>>> mqtt_host = "test.mosquitto.org" >>>>> >>>>> mqtt_port = 8080 >>>>> >>>>> mqtt_ssl = 0 >>>>> >>>>> mqtt_topic = "weather/41south/#" >>>>> >>>>> disconnect_live_website_visitor = 1800000 >>>>> >>>>> On Wed, Sep 5, 2018 at 2:31 PM G Hammer <[email protected]> wrote: >>>>> >>>>>> I can say that my mosquitto install is not using websockets. >>>>>> With mqtt-spy on the server, I can set it up for either default or >>>>>> websockets. >>>>>> Default works fine, websockets does not. >>>>>> Though only item I changed in the mosquitto.conf is protocol >>>>>> websockets >>>>>> >>>>>> So, stumped. Anyone have a working mosquitto install that they would >>>>>> share the conf? >>>>>> >>>>>> >>>>>> >>>>>> >>>>>> On Tuesday, September 4, 2018 at 5:53:18 PM UTC-4, Pat wrote: >>>>>>> >>>>>>> On second glance, use this tool instead. >>>>>>> http://mitsuruog.github.io/what-mqtt/ since it can support SSL >>>>>>> brokers (even though it's not documented). Maybe I should setup my own >>>>>>> websocket test tool? :) >>>>>>> >>>>>>> If your MQTT is setup with SSL, then you'll want to connect to >>>>>>> secure websockets with WSS. Otherwise it'll use normal websockets which >>>>>>> is >>>>>>> ws. >>>>>>> >>>>>>> Example: wss://your.broker.com:port for secure. Then subscribe to >>>>>>> your topic and see if its working >>>>>>> >>>>>>> >>>>>>> >>>>>>> >>>>>>> >>>>>>> On Tuesday, September 4, 2018 at 5:44:14 PM UTC-4, Pat wrote: >>>>>>>> >>>>>>>> The skin - at its core - will show the data from the previous >>>>>>>> archive. Once connected it'll update those fields from the MQTT >>>>>>>> messages. >>>>>>>> >>>>>>>> The MQTT will show "connected" in the status bar once it gets a >>>>>>>> timestamp from the published message. >>>>>>>> >>>>>>>> Check to make sure your broker allows websockets. To validate you >>>>>>>> can use this test tool. >>>>>>>> http://www.hivemq.com/demos/websocket-client/ >>>>>>>> >>>>>>>> If that test tool works, make sure your config options are correct. >>>>>>>> >>>>>>>> Anything in the Chrome console log? >>>>>>>> >>>>>>>> On Tuesday, September 4, 2018 at 4:53:08 PM UTC-4, G Hammer wrote: >>>>>>>>> >>>>>>>>> Hi Colin, >>>>>>>>> >>>>>>>>> I don't think the problem is with sending or retrieving data from >>>>>>>>> the MQTT server, I have done both the test.mosquitto.org and then >>>>>>>>> installed mosquitto on my server. >>>>>>>>> I used MQTT.fx to subscribe to both and both are getting the data. >>>>>>>>> The skin is getting data as it shows the temp, humidity, wind, but >>>>>>>>> never shows a connection and never completes the main page. Graphs on >>>>>>>>> the >>>>>>>>> page are missing/blank but shown on the Graphs page. >>>>>>>>> >>>>>>>>> You can better understand the issue by visiting the site. After >>>>>>>>> you are there for 30 seconds or so, refresh the page and see that the >>>>>>>>> data >>>>>>>>> has changed. >>>>>>>>> My Weather Site <https://ghammer.net/weather/> >>>>>>>>> >>>>>>>> >>>>>>>>> -- >>>>>> You received this message because you are subscribed to the Google >>>>>> Groups "weewx-user" group. >>>>>> To unsubscribe from this group and stop receiving emails from it, >>>>>> send an email to [email protected]. >>>>>> For more options, visit https://groups.google.com/d/optout. >>>>>> >>>>> -- >>>>> You received this message because you are subscribed to a topic in the >>>>> Google Groups "weewx-user" group. >>>>> To unsubscribe from this topic, visit >>>>> https://groups.google.com/d/topic/weewx-user/81PjpX0Ajas/unsubscribe. >>>>> To unsubscribe from this group and all its topics, send an email to >>>>> [email protected]. >>>>> For more options, visit https://groups.google.com/d/optout. >>>> >>>> >>>>> -- >>>> You received this message because you are subscribed to the Google >>>> Groups "weewx-user" group. >>>> To unsubscribe from this group and stop receiving emails from it, send >>>> an email to [email protected]. >>>> For more options, visit https://groups.google.com/d/optout. >>>> >>> -- >>> You received this message because you are subscribed to a topic in the >>> Google Groups "weewx-user" group. >>> To unsubscribe from this topic, visit >>> https://groups.google.com/d/topic/weewx-user/81PjpX0Ajas/unsubscribe. >>> To unsubscribe from this group and all its topics, send an email to >>> [email protected]. >>> For more options, visit https://groups.google.com/d/optout. >> >> >>> -- >> You received this message because you are subscribed to the Google Groups >> "weewx-user" group. >> To unsubscribe from this group and stop receiving emails from it, send an >> email to [email protected]. >> For more options, visit https://groups.google.com/d/optout. >> > -- > You received this message because you are subscribed to a topic in the > Google Groups "weewx-user" group. > To unsubscribe from this topic, visit > https://groups.google.com/d/topic/weewx-user/81PjpX0Ajas/unsubscribe. > To unsubscribe from this group and all its topics, send an email to > [email protected]. > For more options, visit https://groups.google.com/d/optout. > -- You received this message because you are subscribed to the Google Groups "weewx-user" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
