Hello Tanwe and Massimiliano, I have been following this thread with interest. I too have the WaldBeck Halley WH-2650 which I have recently purchase as a backup for my main station.
I have connected it to Weather Underground, Weather Cloud and Met Office with no problems so I know that data streams are being generated and reaching their target. However when I do a network scan with TCPflow, it detects no data flow or any open ports. I am using the interceptor.py and it set up to sniff in observer mode and no interception is happening. I have followed all the suggestions made apart from IP Tables as I cannot install an appropriate firmware on my router to enable this. I am at a loss to see where to go next. Do you have any more ideas that I could pursue? Regards Ian On Friday, November 30, 2018 at 12:41:33 AM UTC, Tanwe Hyalin wrote: > > I changed line 1048 in the interceptor.py file from "if software_type == ' > WH2600GEN_V2.2.5':" to "if software_type == 'WH2600GEN_V2.2.5' or > software_type == 'WH2650A_V1.2.1':" so it could identify our firmware. > > quinta-feira, 29 de Novembro de 2018 às 16:18:52 UTC, Massimiliano Neri > escreveu: >> >> >> Can you tell me the exact line on the code of the interceptor.py? File. >> in fact, after the driver version change the number of lines no longer >> corresponds. I installed the latest version of the driver. is it possible >> that matthewwall fixes the file directly? >> >> Il giorno venerdì 23 novembre 2018 00:11:49 UTC+1, Massimiliano Neri ha >> scritto: >>> >>> Hi, I just bought a WaldBeck Halley WH-2650, basically a clone of the >>> WH-2650 Fine Offset, can you tell me how to configure weewx.conf to >>> intercept its data string? >>> >>> I thank you in advance. >>> >> -- You received this message because you are subscribed to the Google Groups "weewx-user" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
