I haven't used the sniffer mode with the WH2650 so take this with a grain of salt, our bridge is exclusively wifi as such if your router has an option called "Isolation mode" enabled it could hide the device from the interceptor so the first thing I would try would be that, disabling that feature, if that does not work, honestly I don't think there's much you can do besides getting a device to intercept the bridge, either a small router or rasperry pi/orange pi zero just for this purpose. Again the ideal situation would be for a driver that could mimick the WS View app and grab the weather data directly from the station, that why I shared the source code for the app. While I'm slowly analysing the source, I doubt I will be able to create a driver capable of doing that (not enough time or technical skills with network comunication protocols).
sexta-feira, 30 de Novembro de 2018 às 10:44:28 UTC, [email protected] escreveu: > > Hello Tanwe and Massimiliano, > > I have been following this thread with interest. I too have the WaldBeck > Halley WH-2650 which I have recently purchase as a backup for my main > station. > > I have connected it to Weather Underground, Weather Cloud and Met Office > with no problems so I know that data streams are being generated and > reaching their target. However when I do a network scan with TCPflow, it > detects no data flow or any open ports. I am using the interceptor.py and > it set up to sniff in observer mode and no interception is happening. I > have followed all the suggestions made apart from IP Tables as I cannot > install an appropriate firmware on my router to enable this. I am at a loss > to see where to go next. Do you have any more ideas that I could pursue? > > Regards > Ian > > On Friday, November 30, 2018 at 12:41:33 AM UTC, Tanwe Hyalin wrote: >> >> I changed line 1048 in the interceptor.py file from "if software_type == >> 'WH2600GEN_V2.2.5':" to "if software_type == 'WH2600GEN_V2.2.5' or >> software_type == 'WH2650A_V1.2.1':" so it could identify our firmware. >> >> quinta-feira, 29 de Novembro de 2018 às 16:18:52 UTC, Massimiliano Neri >> escreveu: >>> >>> >>> Can you tell me the exact line on the code of the interceptor.py? File. >>> in fact, after the driver version change the number of lines no longer >>> corresponds. I installed the latest version of the driver. is it possible >>> that matthewwall fixes the file directly? >>> >>> Il giorno venerdì 23 novembre 2018 00:11:49 UTC+1, Massimiliano Neri ha >>> scritto: >>>> >>>> Hi, I just bought a WaldBeck Halley WH-2650, basically a clone of the >>>> WH-2650 Fine Offset, can you tell me how to configure weewx.conf to >>>> intercept its data string? >>>> >>>> I thank you in advance. >>>> >>> -- You received this message because you are subscribed to the Google Groups "weewx-user" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
