If you haven't already, it would probably be worth: 1. Checking whether the port is showing up on a physical layer (do you have link on the switch?) 2. Check whether you are seeing mac addresses on the port (on Cisco switches, show mac-address-table). This does require a managed switch.
-Clint Ricker Kentnis Technologies On Dec 13, 2007 11:02 AM, Marlon Schafer <[EMAIL PROTECTED]> wrote: > I've got one doing a similar thing. Every time a change is made to the > unit > (two of them now) it shuts off it's ethernet port. > > Today I'm going to install a different switch. I'm also going to make > sure > that the other radio on that mast and the switch are on the same surge > protector in case there's a goofy grounding or backfeed issue going on. > > In my case I had a Smartbridges APPro up there, worked just fine for > years, > then suddenly started dropping customers. Installed the TR6015 and things > were fine, till it started dropping them too. Now I have a TR6000 in > place > with a Maxrad 60* sector and it acts strange too. Gotta be some kind of > electrical weirdness. Finding it will be the challenging part :-). > > laters, > marlon > > ----- Original Message ----- > From: <[EMAIL PROTECTED]> > To: "WISPA General List" <[email protected]> > Sent: Wednesday, December 12, 2007 10:48 PM > Subject: [WISPA] tranzeo challenges > > > > We have a connectorized tranzeo AP set up to feed a couple clients. > > We've gone through a couple AP radios that have exhibited the same > > symptoms- They power up fine, clients connect up fine, SNR looks good. > > After about 10 mins, the AP stops responding. It's still powered up, > but > > you cant get into it on the ethernet side. Rebooting doesnt help. > > We've swapped everything out. The cable run tests good and is @ 250' > > long. We are using the 18v power supply that came with the unit. Could > > the brick not have enough juice to power the unit at that distance? > Any > > suggestions much appreciated. > > > > Thanks > > Chris > > > > ---------------------------------------------------------------- > > This message was sent using IMP, the Internet Messaging Program. > > > > > > > > > > > -------------------------------------------------------------------------------- > > WISPA Wants You! Join today! > > http://signup.wispa.org/ > > > -------------------------------------------------------------------------------- > > > > WISPA Wireless List: [email protected] > > > > Subscribe/Unsubscribe: > > http://lists.wispa.org/mailman/listinfo/wireless > > > > Archives: http://lists.wispa.org/pipermail/wireless/ > > > > > -------------------------------------------------------------------------------- > WISPA Wants You! Join today! > http://signup.wispa.org/ > > -------------------------------------------------------------------------------- > > WISPA Wireless List: [email protected] > > Subscribe/Unsubscribe: > http://lists.wispa.org/mailman/listinfo/wireless > > Archives: http://lists.wispa.org/pipermail/wireless/ > -------------------------------------------------------------------------------- WISPA Wants You! Join today! http://signup.wispa.org/ -------------------------------------------------------------------------------- WISPA Wireless List: [email protected] Subscribe/Unsubscribe: http://lists.wispa.org/mailman/listinfo/wireless Archives: http://lists.wispa.org/pipermail/wireless/
