So let me get this right. If you have Tranzeo CPE's you only use
StarOS.
MT does not work. Does Mikrotik even acknowledge that this is a issue
and do they have plans to fix it.
Part of the issue is I could not make Cisco VPN's work with StarOS
V3 AP
and a Tranzeo CPE. Had to change to a StarOS CPE. Now I changed to
the
MT AP and the StarOS CPE didn't work right. So I changed the CPE
back to
a Tranzeo, VPN's work great now but the Tower reboots. ARG!!!!!
Steve Barnes
Executive Manager
PCS-WIN
RCWiFi Wireless Internet Service
(765)584-2288
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]
On
Behalf Of Mark Nash
Sent: Wednesday, October 01, 2008 9:50 PM
To: WISPA General List
Subject: Re: [WISPA] Tranzeo/Mtik disconnect issue...
I do wish the Tranzeos had a ping watchdog feature...
----- Original Message -----
From: "Eje Gustafsson" <[EMAIL PROTECTED]>
To: "'WISPA General List'" <[email protected]>
Sent: Wednesday, October 01, 2008 6:27 PM
Subject: Re: [WISPA] Tranzeo/Mtik disconnect issue...
Odd behavior. This must be a mismatch in the protocol between the
Tranzeo
units and MikroTik. We have tested many different units (E-zy.net,
Senao/Engenius, MikroTik, Ubiquiti as well Teletronics) and never
seen
this
behavior you describe. However I do recall way back someone had very
strange
behaviors going on between Tranzeo units and his MikroTik AP. He had
some
Senao CB3 units and some Smartbridges that he swapped some of the
Tranzeo
units with and the problems with those clients went away.
Not sure what the Tranzeo units are or are not doing when
communicating
with
the MikroTik AP thought this been long since fixed but if it was the
problem
seems to once again surfaced.
/ Eje
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]
On
Behalf Of Steve Barnes
Sent: Wednesday, October 01, 2008 3:20 PM
To: WISPA General List
Cc: Scott Reed; Blake King; Rick Harnish
Subject: [WISPA] Tranzeo/Mtik disconnect issue...
I am wondering about a resolution on this. I had a failing StarOS
Board
so I switched out to a Mikotik RB411 v3.10. Now all 45 of my clients
(all are Tranzeo) reset every few minutes. Normally <5min.
I have also noticed that at times the signal Strength on my clients
go
super high like a client at -68 will be at -98. However, if I ping
that
client they drop back to the -68. As soon as you stop the Ping the
signal strength on the AP goes back to -99. If I reboot the Radio it
sets everyone back to Really good signal strength for a while then it
starts to climb. I had no one over -80 on the star board. I just
had
12 clients the MT said was at -112 to -116. Ping them and during the
ping they are back to -68.
Help. I will be a guinea pig if someone wants to look at my tower
from
MT. it can't get much Worse.
Steve Barnes
Executive Manager
PCS-WIN
RCWiFi Wireless Internet Service
(765)584-2288
------------------------------------------------------------------------
----
----
WISPA Wants You! Join today!
http://signup.wispa.org/
------------------------------------------------------------------------
----
----
WISPA Wireless List: [email protected]
Subscribe/Unsubscribe:
http://lists.wispa.org/mailman/listinfo/wireless
Archives: http://lists.wispa.org/pipermail/wireless/
------------------------------------------------------------------------
--------
WISPA Wants You! Join today!
http://signup.wispa.org/
------------------------------------------------------------------------
--------
WISPA Wireless List: [email protected]
Subscribe/Unsubscribe:
http://lists.wispa.org/mailman/listinfo/wireless
Archives: http://lists.wispa.org/pipermail/wireless/
------------------------------------------------------------------------
--------
WISPA Wants You! Join today!
http://signup.wispa.org/
------------------------------------------------------------------------
--------
WISPA Wireless List: [email protected]
Subscribe/Unsubscribe:
http://lists.wispa.org/mailman/listinfo/wireless
Archives: http://lists.wispa.org/pipermail/wireless/
--------------------------------------------------------------------------------
WISPA Wants You! Join today!
http://signup.wispa.org/
--------------------------------------------------------------------------------
WISPA Wireless List: [email protected]
Subscribe/Unsubscribe:
http://lists.wispa.org/mailman/listinfo/wireless
Archives: http://lists.wispa.org/pipermail/wireless/