We've just installed a 3 sector 2.4 setup, at 145' with maxrad 120's. I'm noticing the receive sensitivity on the AP's are about 15-20 db's different then what I see on the CPE's, tried a Tranzeo/Ubiquity radio. I'm using Ubiquity AP's, and they work fine on another 3 sector setup I have, however this tower is an A-Frame. The tower owner won't allow outside climbers so his guy did it, and he put one on each leg at 145' back to back. If the radios were too close together even on different channels, would the RX performance on the AP exhibit this behavior? Only other change on this tower was RFLinx Quarter-wave arrestors in line.
If I'm 3-5 miles away I can see on the CPE a RSSI of -65 to -75 for example, on the AP the reading would be in the -90 to not even below the noise floor. Any thoughts would be appreciated as always. Regards Michael Baird -------------------------------------------------------------------------------- WISPA Wants You! Join today! http://signup.wispa.org/ -------------------------------------------------------------------------------- WISPA Wireless List: [email protected] Subscribe/Unsubscribe: http://lists.wispa.org/mailman/listinfo/wireless Archives: http://lists.wispa.org/pipermail/wireless/
