My first build of the dev version, 1.6.0 r5483. I use a Flex 6300 with Kenwood TS2000 in settings and had Split operation using Rig as used for JT65/JT9 mode. On selecting WSPR and rediscovered the issues already covered of failing to Tx without hopping enabled, and continuous Tx when enabled, I also found I was Txing "out of band" ie 500 Hz too low. So it seems to continue with the use of Slice B for transmit and set this 500 Hz lower than standard dial but not adjust the 1500 Hz audio by the same amount. Probably WSPR does not need this split operation and something needs to ensure that Slice B is fixed on nominal dial in WSPR mode. Split needs to be retained because of the audio settings as typically we have DAX Rx 1 and DAX Tx 2 in settings for split operation on JT modes, else would need separate audio setups for the two modes.
After removing split operation and using single slice A I have had a successful overnight WSPR session. (Apologies if double posted, bounced as sent from wrong account.) Bob Thornton G3WKW ------------------------------------------------------------------------------ _______________________________________________ wsjt-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/wsjt-devel
