I think I have found some unexpected Doppler control behaviour in r5491. This has not yet been verified by other testers, so please treat as preliminary feedback.
What I see is: With Monitor on and Enable TX not red, all modes of Doppler control do not function on RX (as was the case with r5318). With Enable TX activated during a rx period, Doppler works on rx immediately, and also on tx when tx period starts. If Halt TX is pressed midway through a tx period the rig and dial freq stays on tx freq until the end of the tx period, then dial freq turns red at about t=52s. Dial freq turns to normal colour if you touch the rig's tuning. Tune engages Doppler OK and behaviour is normal. If you tune or come to the end of a test, rx stays where it last was from Doppler correction and the only way to get it back to nominal sked frequency is to toggle enable Tx. Occasionally on program start dial frequency is red and rig does not seem to get commands, requiring a TEST CAT before it works. I have not found a way of reproducing this however. Charlie ------------------------------------------------------------------------------ _______________________________________________ wsjt-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/wsjt-devel
