Hi Bill,
Sorry to say, I didn't pay close enough attention or write things down
when I (twice) saw rig control errors. Afterward I continued running
overnight with same program revision and saw no further glitches. So
for me, at least, I'd say don't worry about it until I see another
problem and can document what may have happened.
-- Joe
On 7/8/2015 2:10 AM, Bill Somerville wrote:
> On 08/07/2015 02:56, Joe Taylor wrote:
>> Bi Steve, and Bill --
> Hi Steve& Joe,
>>
>> Similar problem here: several rig control errors in past couple of
>> hours, after weeks of flawless behavior.
> I am surprised by these reports, obviously something has changed but
> between r5685 and r5700 there are no changes that should have any
> bearing on rig control or even application timing. I did update my
> Hamlib fork integration branch with some changes from the master Hamlib
> project but they were not in code that is active for Kenwood rigs and
> that would not explain the problem going on reverting to r5685.
>
> I am away from the shack for most of the net few days but I will try and
> look into this Tonight UK time.
>>
>> -- Joe
> 73
> Bill
> G4WJS.
>>
>> On 7/7/2015 9:13 PM, Steven Franke wrote:
>>> Bill,
>>>
>>> In the past couple of hours since updating to r5700 I have had four rig
>>> control error events after many weeks of flawless operation. “Command
>>> rejected by the rig while setting frequency”
>>>
>>> After program startup the error has occurred after only 1 and as many as 4
>>> transmissions.
>>>
>>> It looks like Tx Enable is dis-abled when the error is thrown. Thereafter
>>> the rig stays on whatever band it was on when the error was thrown, but the
>>> program continues to hop through different bands, causing spots to be
>>> reported on the wrong band.
>>>
>>> This behavior is completely new to me, and it happened immediately after
>>> updating to r5700. I’m not sure what revision I was on before the problem
>>> started, but it was certainly no earlier than r5685. Has anything changed
>>> in the last few revisions that might affect control of a TS-480? e.g.
>>> timing or delay changes maybe?
>>>
>>> Steve k9an
>
>
> ------------------------------------------------------------------------------
> Don't Limit Your Business. Reach for the Cloud.
> GigeNET's Cloud Solutions provide you with the tools and support that
> you need to offload your IT needs and focus on growing your business.
> Configured For All Businesses. Start Your Cloud Today.
> https://www.gigenetcloud.com/
> _______________________________________________
> wsjt-devel mailing list
> wsjt-devel@lists.sourceforge.net
> https://lists.sourceforge.net/lists/listinfo/wsjt-devel
------------------------------------------------------------------------------
Don't Limit Your Business. Reach for the Cloud.
GigeNET's Cloud Solutions provide you with the tools and support that
you need to offload your IT needs and focus on growing your business.
Configured For All Businesses. Start Your Cloud Today.
https://www.gigenetcloud.com/
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
