Hi Bill,
I think I see it the way Mike does: just leave monitor alone, let it
stay the way it was set when doing a band change.
-- Joe
On 6/10/2016 11:01 AM, Bill Somerville wrote:
> On 10/06/2016 15:40, Joe Taylor wrote:
>> I frequently run with Monitor off at startup, most commonly when working
>> on decoder development or optimization. In those circumstances I'm
>> generally using pre-recorded .wav files, and I don't want Monitor to
>> mess up the waterfall or call the decoders at the end of a UTC minute, etc.
>
> Hi Joe,
>
> I was looking at this from the wrong end of the telescope. Are you
> looking for WSJT-X not to turn on monitor when you change mode, even
> where there is a working frequency defined for the target mode?
>
> 73
> Bill
> G4WJS.
>
>
> ------------------------------------------------------------------------------
> What NetFlow Analyzer can do for you? Monitors network bandwidth and traffic
> patterns at an interface-level. Reveals which users, apps, and protocols are
> consuming the most bandwidth. Provides multi-vendor support for NetFlow,
> J-Flow, sFlow and other flows. Make informed decisions using capacity
> planning reports. https://ad.doubleclick.net/ddm/clk/305295220;132659582;e
> _______________________________________________
> wsjt-devel mailing list
> [email protected]
> https://lists.sourceforge.net/lists/listinfo/wsjt-devel
------------------------------------------------------------------------------
What NetFlow Analyzer can do for you? Monitors network bandwidth and traffic
patterns at an interface-level. Reveals which users, apps, and protocols are
consuming the most bandwidth. Provides multi-vendor support for NetFlow,
J-Flow, sFlow and other flows. Make informed decisions using capacity
planning reports. https://ad.doubleclick.net/ddm/clk/305295220;132659582;e
_______________________________________________
wsjt-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
