On 07/02/2017 15:40, Black Michael wrote:
How do you do the simulation?
The TIME_ON defaults to the logging time only when it hasn't been set
yet. Currently only done when Tx 2 or 3 is clicked by either Next or Now.
Are you simulating without clicking? That might 'splain it.
Hi Mike,
two instances of WSJT-X connected by a digital audio loop back. One with
call A and one with call B.
Both call using "CALL-A CALL-B" or "CALL-B CALL-A" as appropriate on
alternate periods. I actually started one somewhat later than the other
as is to be expected sometimes.
Eventually I simulate A see a message from B (or vice versa) after a few
periods by double clicking a decoded message.
Some time later I do the same at the other instance.
Repeat until both have sent and received 73 messages. All replies are
delayed a few periods to simulate a poor communications channel.
BTW the report I had of incorrect times was:
"Sending a message containing 73 now generates a Start Time log entry 2
mins before the actual start of QSO.
This bug began with WSJT-X v1.7.1 r7555."
When I looked into this I could see that there were many edge cases
where QSO start time would not reflect reality.
73
Bill
G4WJS.
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, SlashDot.org! http://sdm.link/slashdot
_______________________________________________
wsjt-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
