On 04/07/2017 03:08, Neil Zampella wrote:
Switching configurations from what I have setup for FT8 to the
'normal' JT65/JT9 setup, the frequency does not move from the FT8 to
the JT modes frequency. This also occurs going the other way. The
only way to reset the frequency is to either re-select the mode from
the mode menu where its already set in the saved configuration, or
re-select the band from the drop down.
I already have two configurations setup for use. The 'normal'
configuration for JT65/JT9 slow modes, and the FT8 configuration.
To reproduce:
1. Change to a different configuration. The system does not reset
the frequency.
2. Re-select band, program changes frequency.
3. Change to a different configuration. The system does not reset
the frequency.
4. Re-select the mode from the mode menu, program changes frequency.
I'm thinking that there's no command sent to the radio to change the
frequency from the last setting. I'm using DX Commander connected to
a KX3, controlling frequencies and tranmission.
Hi Neil,
Have you reset the working frequencies table since building with FT8
support or added some working frequencies for the bands you are using?
As a side note, I would not recommend using Commander as a rig control
intermediary with FT8 mode, it does not process CAT commands fast enough
to switch between Rx and Tx promptly and you will have truncated Tx
messages. Truncated Tx messages will reduce the likelihood your messages
being decoded.
73
Bill
G4WJS.
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
