On 7/4/2017 1:17 PM, Bill Somerville wrote:
On 04/07/2017 15:21, Neil Zampella wrote:
Hi Neil,
I forgot to mention that the two options in WSJT-X
"Settings->General" "Monitor off at startup" and "Monitor returns to
last used frequency" control what happens when you start WSJT-X.
Switching configurations is equivalent to starting WSJT-X again.
73
Bill
G4WJS
Hmmm ... not a factor in my case Bill, as I have neither one of those
checked in any of my configurations.
Hi Neil,
you need "Monitor returns to last used frequency" checked if you are
expecting WSJT-X to change frequency on startup or configuration
switch (in the destination configuration in the case of configuration
switches).
73
Bill
G4WJS.
Hi Bill,
OK .. Scenario I often use is this; I'm monitoring JT65/JT9 on 20M, I
want to switch over to FT8 to see what is happening so I change config.
I'm thinking that the program on restart should check the band and/or
mode to verify the freq setting.
OK .. just tested this: in my FT8 configuration, I check the setting
for 'last used freq', then switched to my JT65/JT9 config and did the
same.
I then switched the config back to my FT8 settings, then selected 40M.
OK - freq is at 7.079. I switch to JT65/JT9 config, the freq doesn't
change it stays on 7.079, doesn't change until I re-select the band, or
re-select the mode. So I'm at the jt65/jt9 freq of 7.076, I switch
back to FT8, the freq changes to 7.079 as it should. So the freq isn't
changing when I go back to the jt65/jt9 config.
Now, the jt65/jt9 config is the 'default' configuration, maybe that has
something to do with it.
Does this clarify anything??
Neil, KN3ILZ
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
