On 04/07/2017 18:52, Neil Zampella wrote:

OK .. Scenario I often use is this; I'm monitoring JT65/JT9 on 20M, I want to switch over to FT8 to see what is happening so I change config. I'm thinking that the program on restart should check the band and/or mode to verify the freq setting.

OK .. just tested this: in my FT8 configuration, I check the setting for 'last used freq', then switched to my JT65/JT9 config and did the same.

I then switched the config back to my FT8 settings, then selected 40M. OK - freq is at 7.079. I switch to JT65/JT9 config, the freq doesn't change it stays on 7.079, doesn't change until I re-select the band, or re-select the mode. So I'm at the jt65/jt9 freq of 7.076, I switch back to FT8, the freq changes to 7.079 as it should. So the freq isn't changing when I go back to the jt65/jt9 config.

Hi Neil,

I know you want to stick with Commander and I do have sympathy with you on that, I use DX Lab Suite myself and I have foregone Commander when using the fast modes and FT8.

Can you try, just for a test, changing your configurations to use direct rig control and see if the problem still happens. You will have to close Commander before starting WSJT-X.

73
Bill
G4WJS.


------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel

Reply via email to