Bill, I see the same problem Neil sees. I have tried both with and without "Monitor returns to last used frequency" checked and see no difference. I still have to manually change the frequency from the dropdown list.
Dan Malcolm - K4SHQ -----Original Message----- From: Bill Somerville [mailto:g4...@classdesign.com] Sent: Tuesday, July 04, 2017 4:08 AM To: wsjt-devel@lists.sourceforge.net Subject: Re: [wsjt-devel] Frequency doesn't shift when changing configurations On 04/07/2017 03:08, Neil Zampella wrote: > Switching configurations from what I have setup for FT8 to the > 'normal' JT65/JT9 setup, the frequency does not move from the FT8 to > the JT modes frequency. This also occurs going the other way. The > only way to reset the frequency is to either re-select the mode from > the mode menu where its already set in the saved configuration, or > re-select the band from the drop down. > > I already have two configurations setup for use. The 'normal' > configuration for JT65/JT9 slow modes, and the FT8 configuration. Hi Neil, I forgot to mention that the two options in WSJT-X "Settings->General" "Monitor off at startup" and "Monitor returns to last used frequency" control what happens when you start WSJT-X. Switching configurations is equivalent to starting WSJT-X again. 73 Bill G4WJS. ---------------------------------------------------------------------------- -- Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ wsjt-devel mailing list wsjt-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/wsjt-devel ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ wsjt-devel mailing list wsjt-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/wsjt-devel
