OK so thats a no go after sending cq 1 time the next time is jumps out
of whack to 880 mhz. I'm thinking it could be a hamlib issue not
responding fast enough or something.
On 12/10/18 9:33 AM, Bill Somerville wrote:
On 10/12/2018 14:23, Steven Greer wrote:
Fake Split Mode not communicating with CAT Correctly. Using Custom
DDS Arduino VFO with Yeasu ft-857D Cat Support... Could be something
on my end as well due to the software Combo I'm using. When I get
connected to rigctl from wsjt-x the fake split works when I tune
Hi Steven,
how are you controlling PTT? Is the "Settings->General->Allow Tx
frequency changes when transmitting" unchecked?
Is the DDS controller interface documented, does it support the full
FT-857/897(D) CAT protocol including any defects?
73
Bill
G4WJS.
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
--
Steven Greer
KM4OUS
OMISS #10630
NOTE: This e-mail was made with 100% recycled electrons. No electrons were
harmed, No trees were destroyed, No animals were killed, and No political
correctness was observed in making or sending this message.
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
