Omni-rig is only running via WSJT. Both are shared against a serial port splitter via VSPE.
There is something about how WSJT handles the control directly, that it wont work (hangs up N1MM when set that way) but when you use omni-rig on the WSJT side things work ok. Mike On Wed, Dec 19, 2018 at 1:28 PM Mike Maynard <m...@k2gc.net> wrote: > It is not the cause. both are 0 > > > On Wed, Dec 19, 2018, 1:27 PM Mike Maynard <mangus...@gmail.com wrote: > >> It is not the cause. both are 0 >> >> On Wed, Dec 19, 2018, 1:18 PM Bill Somerville <g4...@classdesign.com >> wrote: >> >>> On 19/12/2018 18:11, Mike Maynard wrote: >>> > It only happened on UHF though. Wouldnt the calibration fields effect >>> > all frequencies? (although, I guess if they were skewed just >>> right....) >>> > >>> Hi Mike, >>> >>> the frequency offset from the calibration slope adjustment increases >>> with frequency. The intercept point could also counteract the effect at >>> lower frequencies. >>> >>> I suspect the error may be due to a rounding error in Omni-Rig but I >>> cannot confirm that without further diagnostic checks. If the WSJT-X >>> frequency calibration is not the cause we can investigate further. >>> >>> 73 >>> Bill >>> G4WJS. >>> >>> >>> >>> _______________________________________________ >>> wsjt-devel mailing list >>> wsjt-devel@lists.sourceforge.net >>> https://lists.sourceforge.net/lists/listinfo/wsjt-devel >>> >> -- Mike K2GC www.k2gc.net
_______________________________________________ wsjt-devel mailing list wsjt-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/wsjt-devel
