On 19/05/2020 05:15, Stephen VK3SIR wrote:
Hi Folks,
Does the "Allow Tx Frequency Changes While Transmitting" (File/Settings/General
Tab) when not-checked function as intended?
My expectation would be that if disabled that any frequency changes observed in
the Tx spin-box widget on the Main Window should be delayed until the end of
the cycle and should not be immediate (or perhaps these boxes disabled until
the end of the cycle) under this circumstance.
I just performed a slight frequency change on 20m while transmitting and noted that in
the "Rx Frequency Window" that a frequency change during the Tx cycle from 851
to 899 to 900 Hz was noted.
035400 Tx 851 ~ CQ VK3VM QF11
035405 Tx 851 ~ CQ VK3VM QF11
035408 Tx 851 ~ CQ VK3VM QF11
035410 Tx 899 ~ CQ VK3VM QF11
035430 Tx 900 ~ CQ VK3VM QF11
035500 Tx 900 ~ CQ VK3VM QF11
I have also observed some frequency shifts on waterfalls that may or may not be
related to this.
I cannot recall any inquiry on this so far and if I have missed it my apologies.
73
Steve I
VK3VM / VK3SIR
Hi Steve,
that option is intended for rigs that do not accept CAT QSY commands
while transmitting, e.g. the Yaesu FT-817/857/897(D) and others. If no
"Settings->Radio->Split Operating" options are selected then you can
change the Tx audio offset at will since no QSY commands will be sent to
the rig.
73
Bill
G4WJS.
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel