Gentlemen,
To start with, my system is a Dell 1650, i7 @3.40 GHz, 16GB RAM, W10 pro
64bit. I do not use CAT but instead use RTS on COM1 for opto-isolated
PTT and XFR isolation for audio in and out of the sound-card, and have
done so without issue since 2006.
Two problems : -
1. I have found with rc2 that occasionally PTT is not working at all
and when it does there is often no TX audio present either. While
monitoring 'Radio' under 'Settings' I have noticed when this occurs,
after a successful transmission about two seconds into the _RX_ period
the 'Test PTT' button turns red and from that point there is no PTT in
the following TX period. After a time it appears to clear itself and PTT
in the following period with or without TX audio.
2. I am still getting numerous false decodes. Most of these contain
'/R' and '<.....>'. I am not using AP.
Many thanks,
Allan - VK4QG
_______________________________________________
wsjt-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
