That's a different patch that should fix the split problem.
On Wednesday, May 27, 2020, 08:18:34 AM CDT, K2DBK-WSJT
<[email protected]> wrote:
Hi Bill,
I know this was addressed to the other David, but will this resolve the issue I
(and others) have run into using Split (rather than Fake It)?
73,
David, K2DBK
From: Bill Somerville <[email protected]>
Sent: Tuesday, May 26, 2020 5:10 PM
To: [email protected]
Subject: Re: [wsjt-devel] WSJT-X 2.2.0 rc2
Hi Mike and David,
my latest Hamlib patch should sort this out. The issue was a regression, caused
by me, where PTT using RTS or DTR on a serial port, not also used for CAT, was
messed up.
73
Bill
G4WJS.
On 26/05/2020 22:05, Black Michael via wsjt-devel wrote:
Do you have CAT control turned on?
We're still trying to figure out what's causing this.
Mike W9MDB
On Tuesday, May 26, 2020, 03:33:25 AM CDT, David M. Boyter <[email protected]>
wrote:
Morning
I get the same as I use 232 for PTT. Happened about every 2nd transmission
And "tune" button same problem
73
David AE5SB
From: Charles Suckling <[email protected]>
Sent: Tuesday, May 26, 2020 1:35 AM
To: WSJT software development <[email protected]>
Subject: Re: [wsjt-devel] WSJT-X 2.2.0 rc2
Hi Allan
I see exactly the same as you with RS232 PTT.
I hadn't monitored the state of the Test PTT button. As you observe, if this
turns red during a receive period then the following transmission has no audio.
If the button does not turn red during a receive period the following
transmission is OK. Watched the behaviour for a number of periods and this
seems to be consistent.
73
Charlie G3WDG
On Tue, 26 May 2020 at 07:10, Allan VK4QG <[email protected]> wrote:
Gentlemen,
To start with, my system is a Dell 1650, i7 @3.40 GHz, 16GB RAM, W10 pro 64bit.
I do not use CAT but instead use RTS on COM1 for opto-isolated PTT and XFR
isolation for audio in and out of the sound-card, and have done so without
issue since 2006.
Two problems : -
1. I have found with rc2 that occasionally PTT is not working at all and
when it does there is often no TX audio present either. While monitoring
'Radio' under 'Settings' I have noticed when this occurs, after a successful
transmission about two seconds into the RX period the 'Test PTT' button turns
red and from that point there is no PTT in the following TX period. After a
time it appears to clear itself and PTT in the following period with or without
TX audio.
2. I am still getting numerous false decodes. Most of these contain '/R'
and '<.....>'. I am not using AP.
Many thanks,
Allan - VK4QG
_______________________________________________
wsjt-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
_______________________________________________
wsjt-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
